Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

Investigation of the Influence of the Steel 20 Microstructure on the Carbon Dioxide Corrosion Rate

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

Effect of Microstructure and Heat Treatment on Resistance of Steels to Carbon Dioxide Corrosion

CO2 Corrosion of Low Carbon Steel Under the Joint Effects of Time-Temperature-Salt Concentration

Effect of heat treatment on the tribocorrosion behavior of 20Cr13 martensitic stainless steel

Effect of Temperature on CO_2 Corrosion Behavior of Tubular Steel

Effect of temperature on electrochemical corrosion behavior of N80 and KO80SS steels in the stratum water with saturated CO2

Corrosion Electrochemical Behavior of 20 Steel and 16Mn Steel in Simulated CO2 Flooding Environment

Effects of Temperature on CO2 Corrosion of X70 Steel under Multiphase Flow Condition

Corrosion behaviors of steels under supercritical CO2 conditions

Research of Co2 Corrosion Behavior of 20(#) Steel in Gas Well Solution Containing Formic Acid

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

Heat Treatment of Corrosion-Resistant Austenitic-Ferritic Steel For Immersion Pumps

Corrosion Investigation of Commercially Available Linepipe Steel in CO2 Environment

Corrosion Behavior of X65 Steel in Carbon Dioxide Solution under High Temperature and High Pressure

Investigation of Pipe Steels Resistance against Corrosion Caused by Carbon Dioxide in Oil Media of Different Composition. Part 2

Influence Of Microstructure On Mechanical Properties And Corrosion Behavior Of 3%Cr Steel In Co2 Environment

Corrosion Behavior of Heat-Resistant Materials in High-Temperature Carbon Dioxide Environment

Corrosion-Mechanical Properties and Susceptibility to Hydrogenetaion of Pipe Steel in the Presence of Carbon Dioxide Gas and Hydrogen Sulphide in Environment

Cross Impact of CO2 Phase and Impurities on the Corrosion Behavior for Stainless Steel and Carbon Steel in Water-Containing Dense CO2 Environments

Recent progress on the research of steel corrosion behavior and corrosion control in the context of CO 2 geological utilization and storage: a review