Impact on Corrosion of Different Types of EOR Polyacrylamides in Various Conditions of Salinity and Temperature

Julien Bonnier,Vincent Martin,Christophe Rivas
DOI: https://doi.org/10.2118/203023-ms
2020-11-09
Abstract:Abstract Fossil fuels currently supply more than 85% of world's energy, and global energy demand and consumption is forecasted to go up rapidly over the next 20 years [Jamaloei et al., 2011]. Such demand can only be satisfied by sustaining the production of energy in existing fields. Therefore, Enhanced Oil Recovery from existing fields has become increasingly important. Polymer flooding is one of the most efficient EOR technologies that started as early as the late 1950s [Standnes et al., 2014]. Adding polymers increases the viscosity of the injected fluid downhole, which helps to push out viscous crude oil for better oil recovery (up to 10-15% over water flooding) [Standnes et al., 2014] [Taylor et al., 1998]. Among them, Hydrolyzed polyacrylamide (HPAM) is gaining popularity in EOR: inexpensive, it can also withstand high mechanical forces during water flooding [Li et al., 2016] [Wever et al. 2011]. Depending on salinity and temperature, co and ter-polymers of PAM with ATBS may be more relevant to be efficient in highly stressed conditions. Depending on process conditions, industrial equipments such as water pipelines and flowlines are built in seamless carbon steel (CS), stainless steel (SS) and especially duplex (DSS) or superduplex stainless steel (SDSS), capables of transporting fluids at high temperatures and pressures. Since produced water or seawater used in EOR processes bring species prone to induce corrosion (most notably carbon dioxide, hydrogen sulfide and sulfate, dissolved oxygen), several corrosion modes are possible : uniform corrosion of CS, pitting and crevice corrosion of SS, Microbiologically Influenced Corrosion (MIC). Technologies such as upstream deoxygenation of the fluids, addition of oxygen scavengers and corrosion inhibitors and/or addition of biocide are used [Voordouw, 2011]. The corrosion mechanisms of CS in synthetic and industrial brines in presence of CO2 and H2S are often studied, but the effect of viscosifying polymers on corrosion is not well documented. This study aimed to improve the knowledge on the effect of PAM based viscosifying polymers on corrosion of CS and SDSS.
What problem does this paper attempt to address?