Abstract:Hydrocyclone separation technique has commonly been applied in engineering for solid-liquid separation. In aquaculture, since Hydrodynamic Vortex Separator (HDVS) is able to control flocs concentration effectively, the Recirculating Biofloc Technology (RBFT) has been gradually acknowledged (Zhu et al., 2016). In order to operate RBFT system at maximum performance, the removal efficiency of HDVS at different Hydraulic Retention Time (HRT) must be fully predictable. The aim of this work is to investigate the relationship between separation efficiency and HRT of HDVS applied in RBFT system, through Computational Fluid Dynamics (CFD) method. For this, a three-dimensional unsteady transient model was developed to simulate the hydrodynamics in HDVS based on the commercial software Workbenching 17.0. A Two Fluid Model (TFM) using kinetic theory of granular flow (KTGF) has been developed to describe the dense solid-liquid (flocs-water) flow field of HDVS in RBFT system. Additionally, the Reynolds averaged Navier-Stokes (RANS) equations with Reynolds stress turbulence model (RSM) are solved by use of the finite volume method based on the SIMPLE pressure correction algorithm in the computational domain. Finally, pilot-scale studies were conducted to evaluate the accuracy and precision of simulation models applied. The results indicate that the flocs removal efficiency of HDVS obtained from tests were less than that from the simulation results at three different HRTs. But it decreased with the decline of HRT both for experiment and simulation. Additionally, the CFD model proposed can enhance the fundamental understanding of the effects of HRT on separation efficiency and at the same time, probably coupled with physical experiment whenever necessary, offer a more reliable way for optimum control of HDVS under varying conditions. Based on the simulation results, the flocs management in RBFT system is briefly discussed.

Modeling centrifugal separation process of mineral particles in gravity field using finite element method

Study on Separation Mechanism of Falcon Concentrator and Its Application

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

Magnetic-gravity separation in the simulation modeling paradigm

Numerical Study of Dense Solid-Liquid Flow in Hydrodynamic Vortex Separator Applied in Recirculating Biofloc Technology System

Studying the possibilities of improving centrifugal separation efficiency

Gravity separation by falcon concentrator- an over review

Mechanical Model of Non-Magnetic Particles Centrifugal Separation in Magnetic Fluid

Calculation of Evaluation Variables for High Gradient Magnetic Separation with an Idealized Capture Model

Research progress on compound force field separation equipment of fine particles

Application of centrifuge modeling technique in geo-environmental engineering

The reflection in CFD calculations of influence of mass loading on the separation efficiency in a centrifugal separator

An Experimental Study on Aerodynamic Characteristics of Hypergravity Centrifugal Facility

DEM Simulation for Separating Coated Fuel Particles by Inclined Vibrating Plate

A preliminary investigation of dry gravity separation with low specific gravity ores using a laboratory Knelson Concentrator

Particulate flow modelling in a spiral separator by using the Eulerian multi-fluid VOF approach

Numerical Investigation on Influence of Feed Condition on Separation Performance of Gas Centrifuge

Centrifugal dry magnetic separation of fine magnetic minerals

Particle Migration Regularity in Compound Force Field of Enhanced Gravity Concentrator

Simulating the trajectory of conductive particles in positive high-voltage electrostatic separators and optimizing parameters

Investigation of the effects of particle size on the performance of classical gravity concentration equipment