Abstract:Abstract Important hydrocarbon accumulations occur in tight rocks in Colombian areas. Those tight reservoirs consist of clean sandstones with matrix porosities in the 3% to 4% range, relatively complex mineralogy and naturally fractured. The success of achieving a representative formation evaluation relies on obtaining accurate porosity, oil, gas, water saturations, natural fractures detection and good estimates on reservoir permeability. Resistivity-based approaches are difficult to apply since reservoir conductivity is not only influenced by fluid type, but also by salinity (typically low in our reservoirs), variable tortuosity (mostly high in the matrix and very low in fractures) and very high formation resistivity (above 1,000 ohms.m). In addition, a combination of low pores volumes and a matrix not properly assessed, leads to high errors in the porosity determination with conventional logs (in a 3 – 4 p.u. reservoir, the porosity error computation can be as high as 50%). Uncertainties in porosity estimates also translates to uncertainties during saturation assessment. Further challenges are found when attempting the saturation computation from resistivity logs. The tight sands are drilled with Oil Based Muds, creating a logging environment where only induction logs are possible. However, since the resistivity range in these rocks is above 1000 ohm.m range, the induction measurements are out of range in many of the target zones. Alternative formation evaluation methods for assessing fluids saturations, like magnetic resonance, sigma and carbon-oxygen logs cannot be applied below 10 porosity units; whereas dielectric measurements strongly depend on accurate porosity computations for deriving the hydrocarbon volume. Some of these reservoirs, are also deep (in the 17,000 ft range) and close to foothills, where wellbore stability issues and narrow mud weight windows used for drilling, translates into higher risks for open-hole logging via logging while drilling or wireline conveyance, all of it detrimental to data acquisition in open hole. Therefore, the case studies presented in this paper were assessed in cased hole conditions. In this paper, we present a solution that cover tight matrix and natural fractures assessment, at a level not previously achieved. At the tight matrix level, we carry out advanced nuclear spectroscopy with a new pulsed neutron device, that carry out simultaneous time domain and energy domain measurements. A new resistivity and salinity independent methodology for obtaining Gas saturation from a new measurement in the industry known as "Fast Neutron Cross Section" (FNXS), oil saturation from the total organic carbon (TOC) log, mineral volumes solved from formation elemental concentrations from energy domain, and porosity from hydrogen index obtained from the spectroscopy time domain, is presented. At natural fracture level, we make use of a Borehole Acoustic Reflection Service for deep natural fracture detection and spatial orientation analysis, done at cased hole conditions. The main advantages of the new method for obtaining porosity, mineralogy, salinity-independent hydrocarbon saturation in tight matrix and natural fracture assessment behind casing are: 1) conversion of dry weight total carbon to oil saturation, and fast neutron cross section to gas saturation done through a simultaneous inversion by solving matrix-porosity-fluids volumes into an elemental analysis, proven to work at low porosities rocks; 2) independency of salinity and reservoir tortuosity effects; 3) clay and/or other lithology effects is quantified and taken into account; 4) faster logging speeds and improve tools combinability in bigger holes while ensuring full reservoir assessment in small holes; 5) operational time reduction. The spectroscopy logging is carried out in single acquisition pass at 150 to 350-feet per hour (ft/hr), whereas sonic acquisition is done at 400 ft/hr in a single pass as well.

Hydrocarbon Saturation Determination in Case of Total Losses: Invasion Profile Modelling with Dual Resistivity – A Possible Application in PMCD Drilling

The Resistivity Imaging LWD Method Suitable for Oil-Based Drilling Fluid

A Novel Lateral Resistivity Logging-While-drilling (LWD) Method in Oil-Based Drilling Fluid

Signal detection of lateral resistivity LWD based on C4D technique with oil-based drilling fluid

Understanding Lateral Permeability Variations in Heterogeneous Carbonate Reservoirs Using Logging-While-Drilling NMR, Microresistivity Imaging, and Azimuthally Oriented Formation Testing

Identification & Mapping of Water Slumping Fronts by Ultra-Deep Electromagnetic Logging While Drilling Technology in Lower Cretaceous Reservoirs of Adnoc Onshore

Expanding Horizon - A Feasibility Study on Implementing PMCD Operation Using Coiled Tubing Drilling Technology to Develop Marginal Reserves in Karstic Carbonate Reservoir, Offshore Malaysia

Next Level of Complex Reservoir Geosteering: The New Generation of Ultra-High-Definition Directional Resistivity Propagation Method

Cased Hole Solution with Fast Neutrons and Sonic Reflective Waves in Tight Reservoirs

A New Logging-While-Drilling Method for Resistivity Measurement in Oil-Based Mud.

Induction Logging Through Casing by Detecting Lateral Waves: A Numerical Analysis

Multi-Dimensional Approach to Inter-Well Connectivity Analysis

Fully Automatic Managed Pressure Drilling Technology, The Answer to Weeks of Well Complications Including High Temp, Narrow Mud Window & CO2 Influx in Challenging Exploration Wells

Cohesive approach for determining porosity and P-impedance in carbonate rocks using seismic attributes and inversion analysis

Ultra–deep Resistivity Technology as a Solution for Efficient Well Placement; Geosteering and Fluid Mapping to Reduce Reservoir Uncertainty and Eliminate Pilot Hole-First Time in Offshore Abu Dhabi, UAE

Putting the Reservoir to Test: An Innovative Multi-Zone Drill Stem Test Method Revealed Critical Reservoir Characteristics, Horizontal and Vertical Connectivity for Field Development Decisions and Reserve Calculations

Learnings From a New Slimhole LWD NMR Technology

Dynamic Drilling Fluid Invasion Petrophysical Modeling and Corrections in the Presence of Gas Reservoirs - Arab Formation, UAE

Three-Water Differential Parallel Conductivity Saturation Model of Low-Permeability Tight Oil and Gas Reservoirs

Derivation of Continuous Irreducible Water Saturation and Pore Throat Aperture Distribution from Well Logs in an Offshore Brownfield

Formation Evaluation Using NMR, Mud Gas, and Triple-Combo Data – A Norwegian Logging-While-Drilling Case History