Abstract:Thermal evaluation of twin wall panel systems was assessed under vibrant hot and arid conditions of weather in the Arabian Peninsula. Two systems of wall panels (0.6 m × 0.6 m) were prepared. The first system was prepared with a 5.0 cm thick extruded polystyrene (XPS) board. While the second system was prepared with 5.0 cm thick layer of foam-mortar encompassing expanded polystyrene (EPS) beads. Both the thermal insulative layers were sandwiched between two 7.5 cm thick concrete layers. The two wall panel systems were thermally evaluated at the same time in a carefully designed test room. Comparison was accomplished between the two wall systems by measuring the U -value (thermal transmittance) and R -value (resistance). The U -value (air to air) for sandwiched XPS concrete wall system was 0.837 W/m 2 K while it was 2.527 W/m 2 K for sandwiched EPS beads foam-mortar concrete wall system. The mean U -values (surface to surface) of the sandwiched XPS concrete wall system was 1.143 m 2 K/W and 0.293 m 2 K/W for sandwiched EPS beads foam-mortar concrete wall system. The sandwiched XPS concrete wall system was more efficient than the sandwiched EPS beads foam-mortar concrete wall system in terms of thermal performance. About 4.5 h of time lag was observed for both the wall panel systems between the external surface temperature and the heat transmission in the internal surface. The output of the FEM simulation by ABAQUS is compared with the measured data for Set-1 (period 16-Aug-2022 to 26-Aug-2022). The hourly temperature change on the outer and inner surfaces has good agreement for both sandwiched XPS concrete wall system and sandwiched EPS beads foam-mortar concrete wall system. The simulation can also predict the heat flux through the two wall systems investigated.

Heat Transfer Analysis of Reinforced Concrete Walls in ANSYS and ABAQUS: A Comparative Study

EFFECT OF MASONRY MORTAR ON THERMAL INSULATION OF AAC MASONRY

Numerical simulation of the experimental behavior of RC beams at elevated temperatures

Heat Transfer in Ultra-High-Performance Concrete-Filled Double-Skin Tubes Under Fire Conditions

A Comparison between CFD and Thermal-Structural Analysis of Structural Steel Members Subjected to Fire

Numerical Investigation on the Behavior of Reinforced Lightweight Concrete Beams at Elevated Temperature

Numerical Simulation of Deformation and Strength of Reinforced Concrete Slabs under Thermal-Mechanical Loads

ANALYSIS OF THE TEMPERATURE FIELD OF REINFORCED CONCRETE STRUCTURE

A critical analysis of the influence of architecture on the temperature field of RC structures subjected to fire using CFD and FEA models

Numerical and experimental analysis of building walls thermal performance

Numerical Modeling of Masonry Infilled Reinforced Concrete Building during Construction Stages Using ABAQUS Software

Numerical simulation of blast resistance of reinforced concrete slabs under fire conditions

Comparative Thermal Evaluation of Two Systems of Wall Panels Exposed to Hot and Arid Arabian Environmental Weather Conditions

FINITE ELEMENT ANALYSIS OF CONCRETE SPECIMEN

Thermo-Mechanical Analysis of Masonry Brick Walls with Embedded Test Specimen Under Fire Exposure

Comparison of Old and New Stable Explicit Methods for Heat Conduction, Convection, and Radiation in an Insulated Wall with Thermal Bridging

ANALYSIS OF THE THERMAL FIELD OF STEEL-CONCRETE COMPOSITE COLUMNS USING ANSYS

FE analysis of self-consolidating concrete filled double skin tubular columns subjected to fires

Correlation of heat transfer coefficient in quenching process using ABAQUS

Numerical Analysis on Fire Performance of Steel-Reinforced Concrete-Filled Steel Tubular Columns with Square Cross-Section

Numerical study and experimental validation of heat transfer in a CenoPCM reinforced multi-layered meta-material wall for energy efficient buildings