Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

Modelling and measurements of gas tungsten arc welding in argon–helium mixtures with metal vapour

A Theoretical Model of Arc Light Radiation Based on GTA Spectral Diagnosis

Investigation of transient metal vapour transport processes in helium arc welding by imaging spectroscopy

Calculation of Radiative Properties for [82%Ar-18%CO2]-Fe Plasmas in MAG Welding Arc

A theoretical study of a gas metal arc welding system

Analysis of dynamic plasma behaviours in gas metal arc welding by imaging spectroscopy

Spectroscopic analysis of the arc plasma during activating flux tungsten inert gas welding process

Numerical Simulation of Arc and Droplet Behaviors in TIG-MIG Hybrid Welding

The effects of process parameters on melt-pool oscillatory behaviour in gas tungsten arc welding

Analysis of dynamic plasma behaviors in gas metal arc welding by imaging spectroscopy

Numerical simulation of GMAW process using Ar and an Ar–CO2 gas mixture

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

Effects of He-Ar shielding gas compositions on arc plasma physical properties in rotating laser + GMAW hybrid fillet welding: Numerical simulation

3D Numerical Investigation of a Free-Burning Argon Arc with Metal Electrodes Using a Novel Sheath Coupling Procedure

Thermodynamic Insights into the Influence of Welding Current on Oxygen Levels in the Submerged Arc Welding Process

Physical and Theoretical Modeling of the Nitrogen Content of Duplex Stainless Steel Weld Metal: Shielding Gas Composition and Heat Input Effects

2D Self-Consistent Modeling of Arc–electrode Interaction in GTAW Using a Finite Volume Method

Influence of reduced pressure on arc and weld pool properties in TIG welding

Variation of Surface Tension of Liquid Metal with Fluorides in Tungsten Inert Gas Welding

Numerical simulation on molten pool behavior of narrow gap gas tungsten arc welding

Visualization of gas metal arc welding on globular to spray transition current