Abstract:Titania-based nanocomposites have recently attracted much attention due to their unique structure and properties. Titania has been known to have three crystal phases: brookite, anatase and rutile. The anatase titania has the highest photoactivity than the other two phases. Meanwhile Ohtani et al. [1] reported that amorphous titania has a negligible photoactivity compared to the crystalline titania. Much work has been conducted on the optimization of catalytic properties of titania used in the photodegradation of organic pollutants in water by either using modified titania or thin titania films. Many researches indicated that dopants, such as many oxides, can effectively suppress the transformation of anatase into rutile by improving the onset transformation temperature [2]. Silica-titania mixed oxide is considered a potential candidate because it is used as not only a good photocatalyst itself but also a support material for other chemical reaction catalysts [3, 4]. 30SiO2/TiO2 powders (30 denotes the weight percent of silica) were prepared by sol-gel process. Ti(OBu n )4 and TEOS were used as precursors of titania and silica respectively. After TEOS was stirred in a mixture solution of pure ethanol, distilled water and hydrochloric acid for 1 h, Ti(OBu n )4 was added slowly into the mixture. The sol of SiO2/TiO2 was obtained after another two hours’ vigorous stirring and cooled to room temperature. The gel was calcined at different temperatures and then ground into fine powders. The distilled water solution of methyl orange (with a concentration of 25 mg/L) was chosen for photodegradation. 0.2 g powders were added into 40 ml of the above solution with vigorous agitation under the mercury light. A 756MC UV-VIS spectrometer was used to record the change of concentration of the methyl orange. FT-IR spectra was obtained by a Bruker EQUINOX55 spectrometer. TEM and HREM observations were carried out using a Jeol-2010 electron microscope. The XRD patterns were made in a D/max3A diffractometer with Cu Kα radiation. The crystallite size of powders was determined by Scherrer equation. Electron spin resonance measurements were made with a Bruker paramagnetic spectrometer. X-ray photoelectron spectroscopy (XPS) spectra of the sample were obtained with an NP-1 using the Mg Kα excitation source and the binding energies referenced to the C1s hydrocarbon line at 284.6 eV. The atomic ratios were obtained by intergrating the areas under the peak. Photodegradation for methyl orange with 30SiO2/ TiO2 samples calcinated at different temperature under UV irradiation is illustrated in Fig. 1. The results of other samples heated at temperatures higher than 850 ◦ C were not shown in this figure because further increase of the calcination temperature decreased the decomposition rate. It can be seen that decomposition rate of the samples fired at 400 ◦ C and 500 ◦ Ci s low. When the calcination temperature was further increased to 600 ◦ C, the higher photoactivity than Degussa P25’s was obtained. The sample heated at 800 ◦ C has the best photoactivity about 2 times higher than the Degussa P25.

Enhancing photocatalytic ability of TiO2 films using gel-derived P/Si-TiO2 powder

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

P-doped TiO_2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light

Enhanced Photocatalytic Activity of Tio2 Thin Film Coating on Microstructured Silicon Substrate

Investigation of TiO2 Deposit on SiO2 Films: Synthesis, Characterization, and Efficiency for the Photocatalytic Discoloration of Methylene Blue in Aqueous Solution

(001)-Exposed TiO2 Microcrystals Decorated with Few-Layer Nanobelts for Enhanced Photocatalytic Activity

Photocatalytic activity of TiO 2 nanorods, nanowires and nanoflowers filled with TiO 2 nanoparticles

Fabrication and Photocatalytic Properties of Porous Crystalline Titanium Dioxide Film Co-Doped with Fe and Si by PEO

Enhanced photoactivity of silica-titania binary oxides prepared by sol-gel method

Photocatalytic Active Titania Thin Films Through Oxidation of Metallic Ti in Aqueous H2O2 Solutions Containing Various Block Copolymers

Effect of Calcined Atmosphere on the Photocatalytic Activity of P-doped TiO2

Influence of Doping the Nanosized SiO2 Powder on Structure and Activity of Photocatalytic Films

One-Step Synthesis Of Bifunctional Tio2 Catalysts And Their Photocatalytic Activity

Substrate-Assisted Crystallization and Photocatalytic Properties of Mesoporous Tio2 Thin Films

Mesoporous SiO2-Modified Nanocrystalline TiO2 with High Anatase Thermal Stability and Large Surface Area As Efficient Photocatalyst

Preparation of TiO2–SiO2 film with high photocatalytic activity on PET substrate

Preparation and photocatalytic performance of anatase-mounted natural porous silica, pumice, by hydrolysis under hydrothermal conditions

Ag/Co/B Tri-Doped TiO2/SiO2 Film for Enhancing Photocatalytic Degradation

Enhanced Photocatalytic Activity of P25 TiO2 after Modification with Phosphate‐Treated Porous SiO2

Preparation and Photocatalytic Performance of TiO2 Thin Films

Synthesis and Photocatalytic Property of SiO2/TiO2