Abstract:The sliding of laminated rubber bearings (LRBs) and failure of shear keys observed in the Wenchuan earthquake significantly increase the span collapse risk of simply-supported highway bridges and contradict the ductile design philosophy recommended by the current design code in China. In the meantime, the seismic damage mode of bridges may also change with increasing service time due to environmental corrosion sustained by the ductile element of pier. It is well accepted that the change of bridge damage mode will cause the ineffectiveness of original seismic design. In order to identify transverse seismic damage modes of deteriorating simply-supported bridges, a five-span bridge is selected as the baseline bridge and a series of time-dependent models considering the chloride intrusion are developed. A methodology for identifying the seismic damage mode of the bridge system is proposed. Incremental dynamic analyses (IDAs) are performed to study the effects of service time and shear key capacity on seismic damage modes of the baseline bridge. To validate the results obtained from the baseline bridge, comparisons of the lifetime damage modes for several typical bridge configurations are conducted through the proposed methodology. The results indicate that with the increase of the service time of bridge, the displacement response of LRBs decreases slightly while the displacement ductility response of piers increases significantly under earthquakes, and the seismic damage mode of the bridge shows a trend of changing from displacement-oriented to strength-oriented or combined damage modes. On the other hand, the increase of shear key capacity can effectively prevent excessive girder movement but intensifies the damage level of piers under earthquakes, which is in accordance with the expectations of the ductile design philosophy. In conclusion, the combined effects of environmental corrosion and shear key capacity can significantly change the seismic damage modes of bridges along the transverse direction and thus should be considered carefully during the seismic design.

Effect of bonding or unbonding on seismic behavior of bridge elastomeric bearings: lessons learned from past earthquakes in China and Japan and inspirations for future design

Earthquake Response of Bridge Restrainers Considering Failure of Bearings

Effect of Transverse Earthquake Action on Development of Seismic Damage of Steel Arch Bridges

A Method for Controlling Seismic Damage of RC Bridge Piers Subjected to Strong Aftershocks

Earthquake response of bridges bearing on flexible rubber considering pounding of girders

Effect of Rail Restraints on Seismic Responses of Cushioning Railway Bridges

SEISMIC DESIGN METHOD OF SMALL AND MEDIUM SPAN BRIDGE CONSIDERING BEARING FRICTION SLIPPING

Yielding Steel Dampers as Restraining Devices to Control Seismic Sliding of Laminated Rubber Bearings for Highway Bridges: Analytical and Experimental Study

Problems in Chinese Highway Bridge Seismic Specifications and Suggestions for Improvement

Seismic Study of Skew Bridge Supported on Laminated-Rubber Bearings

Seismic performance of near-fault girder bridges based on laminated rubber bearings under the impact of sequential earthquakes

A study of the concrete continuous girder bridge shaking table test considering the sliding of laminated rubber bearings

Seismic Vulnerability Analysis of Concrete-Filled Steel Tube Tied Arch Bridges Using Symmetrically Arranged High-Damping Rubber Bearings

Analysis Of Longitudinal Seismic Response Of Bridge With Magneto-Rheological Elastomeric Bearings

Seismic Performance Of A Multi-Span Rc Highway Bridge With High Damping Rubber Bearings

Seismic performance of bridges with novel SMA cable‐restrained high damping rubber bearings against near‐fault ground motions

Transverse seismic damage mode identification of deteriorating simply-supported highway bridges

Seismic Study of an Isolated Cable-Stayed Bridge under Near-Fault Ground Motions

Lead-rubber-bearing with negative stiffness springs (LRB-NS) for base-isolation seismic design of resilient bridges: A theoretical feasibility study

Effects of friction-based fixed bearings on the seismic vulnerability of a high-speed railway continuous bridge

A SMA-based sliding friction damper for enhancing the transverse seismic performance of isolated bridges