Abstract:Modified two-surface model (M2SM) is one of the steel elasto-plastic hysteretic constitutive models that consider both analysis accuracy and efficiency. However, when M2SM is used for complex strain history, sometimes the results are irrational due to the limitation of stress-strain path judgment. In this paper, the defect of M2SM was re-modified by improving the judgment of stress-strain paths. The accuracy and applicability of the improved method were verified on both material and structural level. Based on this improvement, the nonlinear time-history analysis was carried out for a deck-through steel arch bridge with a 200 m-long span under the ground motions of Chi-Chi earthquake and Niigata earthquake. In the analysis, we compared the results obtained by hysteretic constitutive models of improved two-surface model (I2SM) presented in this paper, M2SM and the bilinear kinematic hardening model (BKHM). Results show that, although the analysis precision of displacement response of different steel hysteretic models differs little from each other, the stress-strain responses of the structure are affected by steel hysteretic models apparently. The difference between the stress- strain responses obtained by I2SM and M2SM cannot be neglected. In significantly damaged areas, BKHM gives smaller stress result and obviously different strain response compared with I2SM and M2SM, and tends to overestimate the effect of hysteretic energy dissipation. Moreover, at some position with severe damage, BKHM may underestimate the size of seismic damaged areas. Different steel hysteretic models also have influences on structural damage evaluation results based on deformation behavior and low cycle fatigue, and may lead to completely different judgment of failure, especially in severely damaged areas.

Effect of Transverse Earthquake Action on Development of Seismic Damage of Steel Arch Bridges

Damage Characteristics of Thin-Walled Steel Arch Bridges Subjected to In-Plane Earthquake Action

Study on FE Models in Elasto-Plastic Seismic Performance Evaluation of Steel Arch Bridge

Residual seismic performance of steel bridges under earthquake sequence

Effect of Hysteretic Constitutive Models on Elasto-Plastic Seismic Performance Evaluation of Steel Arch Bridges

Investigation of elasto-plastic seismic response analysis method for complex steel bridges

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

Seismic Damage of Long Span Steel Tower Suspension Bridge Considering Strong Aftershocks

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

A Method for Controlling Seismic Damage of RC Bridge Piers Subjected to Strong Aftershocks

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

Influence of strong spatially varying near fault ground motion on steel box arch bridge

An Investigation into the Impact of Time-Varying Non-Conservative Loads on the Seismic Stability of Concrete-Filled Steel-Tube Arch Bridges

Seismic performance assessment and retrofitted by buckling-restrained braces for half-through concrete-filled steel tubular arch bridge with the vertical suspended deck system

Random Seismic Response Analysis of Long-Span Arch Bridge under Three-Dimentional Multi-Supports Excitation

Seismic performance analysis of a concrete filled steel tubes arch bridge: A parametric study

Research on the Mechanical Performance of a Mountainous Long-Span Steel Truss Arch Bridge with High and Low Arch Seats

Influencing factors analysis of degradation and damage and the effect on steel frame

Experimental study on longitudinal seismic damage progress and failure mode of a three-tower extradosed bridge

A Simplified Analysis Method for Reinforced Concrete Arch Bridge under Exceptionally Serious Earthquake