Abstract:The anodic bubbles generated in aluminum electrolytic cells play a complex role to bath flow, alumina mixing, cell voltage, heat transfer, etc., and eventually affect cell performance. In this paper, the bubble dynamics beneath the anode were observed for the first time from bottom view directly in a similar industrial electrolytic environment, using a laboratory-scale transparent aluminum electrolytic cell. The corresponding cell voltage was measured simultaneously for quantitatively investigating its relevance to bubble dynamics. It was found that the bubbles generated in many spots that increased in number with the increase of current density; the bubbles grew through gas diffusion and various types of coalescences; when bubbles grew to a certain size with their surface reaching to the anode edge, they escaped from the anode bottom suddenly; with the increase of current density, the release frequency increases, and the size of these bubbles decreases. The cell voltage was very consistent with bubble coverage, with a high bubble coverage corresponding to a higher cell voltage. At low current density, the curves of voltage and coverage fluctuated in a regularly periodical pattern, while the curves became more irregular at high current density. The magnitude of voltage fluctuation increased with current density first and reached a maximum value at current density of 0.9 A/cm2, and decreased when the current density was further increased. The extra resistance induced by bubbles was found to increase with the bubble coverage, showing a similar trend with published equations.

Prevention and Control Measures of the Cathode Voltage Drop Rise of Aluminum Electrolytic Cell Due to Unstable Power Supply Load

High-capacity Multi-level Emergency Load Shedding Technology for Electrolytic Aluminum Load

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Mitigating Cathode Corrosion in Aluminum Reduction Cells Using a VOF-Electric Model

Chemical Degradation of the Cathodic Electrical Contact Between Carbon and Cast Iron in Aluminum Production Cells

Improved CFD Modeling of the Whole-Cell Side Ledge Behavior in Aluminum Electrolysis Cell

Anodic Bubble Behavior and Voltage Drop in a Laboratory Transparent Aluminum Electrolytic Cell

Influence of Cell Operation on Cathode Life in Aluminum Reduction

Simulation and Application of a New Type of Energy-Saving Steel Claw for Aluminum Electrolysis Cells

Influences of various aluminum accumulation sump designs on thermal stress distribution in drained aluminum reduction cell

Method of Controlling the Energy Balance of Electrolytic Cells for Aluminum Production

Voltage oscillations during anodizing process of aluminum and their suppression

Oscillating Currents Stabilize Aluminum Cells for Efficient, Low Carbon Production

Thermo-mechanical Studies of Thimble Geometry and Stub Materials for Voltage Drop Across the Anode-Rod Connection in Aluminum Electrolysis Cell

Alkali assisted water treatment of aluminum promoting the growth of hydrated oxide film for energy conservation

Influence of Current Density on the Microstructure of Carbon-Based Cathode Materials During Aluminum Electrolysis

Fully-Coupled Electric-Thermal-Flow Modeling and Investigation of Dynamic Thermal-Ledge Behavior in Aluminum Electrolysis Cell

Development and Application of an Energy Saving Technology for Aluminum Reduction Cells

Simulation and Analysis of Magnetic Fields and Flow Fields of Metal Pad in 75 Ka Drained Style Aluminum Reduction Cell

Mode Coupling Analysis of Interfacial Stability and Critical Anode–Cathode Distance in a 500-kA Aluminum Electrolysis Cell

Effect of cetyl trimethyl ammonium bromide as an electrolyte additive on secondary discharge performance of aluminum-air battery