Abstract:A solid oxide fuel cell anode microstructure is obtained using X-ray technology. A complete three-dimensional (3D) and fine heterogeneous model is built on the basis of the microstructure. The difference between the simulation results of microscopic and macroscopic models is compared. The physical fields of the heterogeneous model are analyzed and the effects of operating conditions are investigated. The results show that the electrochemical reaction at three-phase boundaries does not cause a high concentration gradient in the pore phase. The H-2 molar fraction and concentration overpotential almost linearly decrease with the anode depth. However, the decrease of the H-2 molar fraction is small, indicating that fuel supply is sufficient. Compared with activation and ohmic overpotentials, the concentration overpotential is negligible. Given the heterogeneity of the microstructure, the physical fields of the anode would fluctuate. The higher the electrochemical reaction rate, the greater the fluctuation of the physical fields. As shown in the microscopic simulation result, the active thickness of the anode is expressed as the analytical function of the operating conditions and microstructure parameters. The active thickness increases with temperature and H-2 molar fraction but slightly decreases with the total overpotential. The active thickness is analytically expressed as the function of electrode parameters and operating conditions, which can improve electrode design and optimization.

Thermo-mechanical Studies of Thimble Geometry and Stub Materials for Voltage Drop Across the Anode-Rod Connection in Aluminum Electrolysis Cell

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Improved CFD Modeling of the Whole-Cell Side Ledge Behavior in Aluminum Electrolysis Cell

Reduced Order Electrochemical-thermal Modeling of Cylindrical Cells Containing Graphite-Silicon Anodes Considering Thermal Gradients and Hysteresis

Technology Research on Decreasing the Aluminum Surface Waves and Reducing the Cathode Voltage Drop in Aluminum Electrolysis Cell

Fully-Coupled Electric-Thermal-Flow Modeling and Investigation of Dynamic Thermal-Ledge Behavior in Aluminum Electrolysis Cell

A Transient Model of the Anodic Current Distribution in an Aluminum Electrolysis Cell

3D Thermo-Electric Coupling Analysis of the Diaphragmless Magnesium Reduction Cell

Chemical Degradation of the Cathodic Electrical Contact Between Carbon and Cast Iron in Aluminum Production Cells

Mitigating Cathode Corrosion in Aluminum Reduction Cells Using a VOF-Electric Model

Numerical Simulations and Thermal Diagnostic of Ledge Formation in Hall–Heroult Aluminum Electrolysis Cell with a Solidification Front at the Cryolite-Metal Baths Interface for Reduction of Heat Losses

Influences of various aluminum accumulation sump designs on thermal stress distribution in drained aluminum reduction cell

Thermal Stress Analysis at the Interface of Cathode and Electrolyte in Solid Oxide Fuel Cells

Analysis of 3D Thermo - Electric Field Potential for 300 Ka Aluminum Electrolysis Cell Using ANSYS

Modeling and Parametric Study of Spent Refractory Material Dissolution in an Aluminum Reduction Cell

Three-Dimensional Microscopic Modeling And Activation Thickness Analysis Of The Anode Of Solid Oxide Fuel Cells

Simulation and Analysis of Magnetic Fields and Flow Fields of Metal Pad in 75 Ka Drained Style Aluminum Reduction Cell

Influence of Current Density on the Microstructure of Carbon-Based Cathode Materials During Aluminum Electrolysis

Thermal Designing of an Inner Cathode Type Alkali Metal Thermal to Electric Conversion (AMTEC) Cell

Study of a Novel Cathode Tool Structure for Improving Heat Removal in Electrochemical Micro-Machining