Abstract:To diagnose the state of stay cables, a vibration-based model-free damage diagnosis method of stay cables using the changes in natural frequencies is further proposed and validated. The structural frequency is rapidly and easily acquired; moreover, it is simple and reliable for damage diagnosis. The frequency would change after the stay cable is damaged, so the frequency change could be used as the damage index. However, the stay cables are very long in long-span cable-stayed bridges, and their frequencies are very small; the frequency change due to small damage of the stay cable would be submerged by the surrounding noise and error of parameter identification process. A temporary diagonal steel bar–based method is used to solve this issue. The steel bar is installed with one end on the stay cable close to the bottom anchor head and the other end on the bridge deck; thus, the stay cable is divided into a short part and a long part by the steel bar. The frequency of a stay cable with a given tension force increases with the decrease in its length; according to the qualitative analysis, the frequency of the short part increases dramatically, and the local frequency change of the short part due to the same damage in the whole stay cable is amplified dramatically; thus, the small damage of a stay cable can be diagnosed easily. Numerical simulations of a stay cable selected from a cable-stayed bridge and a laboratorial stay cable are used to validate the method and also give a recommended rule for design of the temporary diagonal steel bar; experimental validation has also been conducted. All the results indicate that the proposed method works very well in damage diagnosis of stay cables. The proposed method is an output-only, model-free, fast and economical damage diagnosis method for stay cables.

Guided wave‐based cable damage detection using wave energy transmission and reflection

Ultrasonic Guided Wave Approach Incorporating SAFE for Detecting Wire Breakage in Bridge Cable

Guided wave based cable damage detection using magneto-strictive transducer

Numerical and Experimental Investigation of Guided Wave Propagation in a Multi-Wire Cable

Feasibility of non-destructive testing for aluminium sheaths of HV cables using ultrasonic guided waves

Vibration-Based Damage Detection Of Cable-Stayed Bridges

Damage detection method for cables based on the change rate of wavelet packet total energy and a neural network

Numerical simulation of cable sheath damage detection based on torsional mode guided wave

Cable damage detection method based on traveling wave analysis

Damage Detection in Thick Steel Beam Based on Elastic Guided Wave

Guided Wave Propagation Based Damage Detection in Welded Rectangular Tubular Structures

Investigation of wave propagation path and damage source 3D localization in parallel steel wire bundle

A Novel Mode Sharp-Based Damage Detection Method of Large-Span Bridges

Damage detection method for structures based on the relative variation of wavelet total energy

DAMAGE DETECTION METHOD OF CABLE STRUCTURE CONSIDERING GRAVITY EFFECT BASED ON MEASURED TRAVELING WAVE DATA

Experimental and Numerical Studies on A Test Method for Damage Diagnosis of Stay Cables

Damage Propagation Monitoring and Fatigue Properties of Parallel Wire Cable

Structural Damage Warning of a Long-Span Cable-Stayed Bridge Using Novelty Detection Technique Based on Wavelet Packet Analysis

Damage Detection and Assessment of Broken Wires in Cables of a Bridge Based on Magnetic Flux Leakage

STRUCTURAL DAMAGE MONITORING ON OVERHEAD TRANSMISSION LINES USING GUIDED WAVES AND SIGNAL PROCESSING