Biomass-Derived Carbonaceous Materials with Multichannel Waterways for Solar-Driven Clean Water and Thermoelectric Power Generation

Xinghang Liu,Debesh Devadutta Mishra,Yuankai Li,Long Gao,Hongyan Peng,Ling Zhang,Chaoquan Hu

DOI: https://doi.org/10.1021/acssuschemeng.0c09177

2021-03-09

Abstract:Coping with the shortage of fresh water and electricity in off-grid and resource-constrained areas through sustainable strategies has become the most urgent challenge facing the development of human society. Herein, we propose a low-cost and sustainable way of repurposing discarded pomelo peel by converting it into 3D porous carbon foam (i.e., carbonized pomelo peel, referred to as CPP) with multichannel waterways for synergetic coupling of solar-driven interfacial evaporation (SDIE) and low-grade heat-to-electricity generation. The superhydrophilic 3D porous CPP with multichannel waterways utilizes its powerful water supply capability to avoid salt accumulation during continuous seawater desalination. By cautiously weighing the water transport and thermal management of CPP-based evaporators, CPP with three-channel waterways (CPP3) can achieve efficient solar-driven evaporation (the evaporation rate of 1.37 kg m^–2 h^–1, one sun) on the premise of salt resistance through its superior light absorption and ultrafast solar-thermal response. Besides, a collaborative device integrating CPP3 and a commercial thermoelectric (TE) generator is designed for synchronous generation of solar steam and thermoelectricity, which can simultaneously achieve an evaporation rate of 1.39 kg m^–2 h^–1 and a power output of 0.5 W m^–2 under one sun illumination. Such a cost-effective and easy-to-manufacture strategy can provide potential opportunities for satisfying the demand for fresh water and electricity in resource-constrained areas.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssuschemeng.0c09177?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssuschemeng.0c09177</a>.Experimental flow chart for preparing 3D porous CPP with multichannel waterways (Figure S1); schematic diagram of "the sandwich method" for measuring the thermal conductivity of CPP (Figure S2); mass change as a function of the dark environment, including pure water, CPP2, CPP3, and CPP4 (Figure S3); pore size distributions of NPP and CPP (Figure S4); XRD pattern of CPP (Figure S5); dynamic wetting of the water droplet on NPP and CPP (Figure S6); transmittance and reflectance spectra of NPP and dry- and wet-state CPPs (Figure S7); IR images of pure water, CPP2, CPP3, and CPP4 (Figure S8); change of the evaporation surface of CPP2 after 60 min of illumination (Figure S9); comparison of power output of simultaneous steam–electricity-generation strategies (Figure S10); analysis of the heat loss of CPP3; and essential parameters of different SDIE systems (Table S1) (<a class="ext-link" href="/doi/suppl/10.1021/acssuschemeng.0c09177/suppl_file/sc0c09177_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

chemistry, multidisciplinary,engineering, chemical,green & sustainable science & technology