Abstract:Janus structural interfacial vaporization by separating the solar absorber from the bulk working fluid has attracted tremendous attention due to its low heat losses and high solar conversion efficiency for desalination, water purification, energy generation, etc. However, a totally separated double-deck structure with a discontinuous interfacial transition and inefficient photothermic materials undermines its long-term use and large-scale practical exploitation. Herein, a low-cost Janus monolithic chitosan aerogel with continuous aligned run-through microchannels has been demonstrated to have a highly efficient photothermic effect on seawater desalination and wastewater purification. The top solar absorber layer enhances broadband light absorption and photothermal conversion efficiency via the multiple internal reflection of incident light in the aligned microchannels. Moreover, the insulating/hydrophilic bottom layer promotes water transportation and heat localization, and simultaneously prevents salt/fouling accumulation. As a result, a long-term solar vaporization rate of ∼1.76 kg m<sup>–2</sup> h<sup>–1</sup> is achieved, corresponding to a light-to-vapor efficiency of ∼91% under 1 sun irradiation. Notably, the large-vessel microchannels throughout the aerogel and favorable swelling property provide sufficient water replenishment and storage for completely isolating self-contained evaporation, illustrating an enhanced and time-extended self-contained solar steam generation. Such a low-cost bilayer aerogel with remarkable cycling stability in various fluids offers potential opportunities for freshwater production in remote rural areas.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c02198?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c02198</a>.Pore size distribution and surface morphology of CS, CCS-60, CCS-240 and CCS-480; FT-IR spectra of the CCS-240 and CCS-480; Raman spectra of CCS-60, CCS-240 and CCS-480; XPS spectra of NFs and high–resolution XPS spectra of CS, CCS-60, CCS-240 and CCS-480 for N 1s and C 1s; thermogravimetric analysis (TGA) and differential thermal gravimetric (DTG) analysis of CS, CCS-60, CCS-240 and CCS-480; axial compressive stress-strain curves of CCS-240 and CCS-480; photographs of the soaking unchanged CCS-60 after two months; transmittance and reflectance spectra of CCS-240 and CCS-480; the hydrophilic property of CS, CCS-60, CCS-240 and CCS-480; calculation of evaporation conversion (photothermal) efficiency of CCS; interfacial water evaporation efficiency from the selected typical publications; the total pore volume of CS and CCS; calculation of estimating the cost of CCS; photographs of the swollen changes of CCS immersed in a solution with different pH values over time; calculation of absorption capacity; swelling measurements; evaporation mass loss in suspending and containing configurations; and infrared images of the solar evaporation processes of CCS-60 containing configuration at the beginning and after 5 h later (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c02198/suppl_file/am1c02198_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Biomass-Derived Bilayer Solar Evaporator with Enhanced Energy Utilization for High-Efficiency Water Generation

Multi-Shelled Hollow Porous Carbon Nanospheres-Based Evaporator for Highly Efficient Solar-Driven Desalination

A Bifunctional MoS2-based Solar Evaporator for Both Efficient Water Evaporation and Clean Freshwater Collection

A Salt-Rejecting Solar Evaporator for Continuous Steam Generation

Self-contained Janus Aerogel with Antifouling and Salt-Rejecting Properties for Stable Solar Evaporation

A 3D aerogel evaporator for efficient solar interfacial evaporation: Breaking through the upper limit of steam production rate

Solar-driven water evaporation using a collaborative photothermal conversion material system based on carbonized waste polyphenylene sulfide and copper sulfide

Enhanced Solar-to-Heat Efficiency of Photothermal Materials Containing an Additional Light-Reflection Layer for Solar-Driven Interfacial Water Evaporation

Sandwiched solar interfacial evaporation system: Integrating phase change material/hydrogel/NiCo 2 O 4 nanoflower for superior desalination

Bilayer Designed Paper-Based Solar Evaporator for Efficient Seawater Desalination

Universal Strategy to Prepare a Flexible Photothermal Absorber Based on Hierarchical Fe-MOF-74 toward Highly Efficient Solar Interfacial Seawater Desalination

Construction of a biomimetic wood structure with cellulose nanofiber/ molybdenum disulfide hybrid aerogel for highly-efficient solar-driven interfacial evaporation

Synergistic dual-mechanism raised structure and vertically aligned porous 3D hydrogel fabric for ultra-high salt-resistant water desalination

Efficient evaporation of seawater desalination by novel double-interface evaporator: Photothermal conversion, water transfer and salt-resistant

Multifunctional Super‐Hydrophilic MXene/Biomass Composite Aerogel Evaporator for Efficient Solar‐Driven Desalination and Wastewater Treatment

Bio-inspired molybdenum carbide/carbon-based aerogel with advanced thermal management as a solar evaporator

Sustainable solar desalination through interfacial evaporation - integration of chitosan aerogel-impregnated graphene nanoplatelets solar evaporator and phase change material

Water Delivery Channel Design in Solar Evaporator for Efficient and Durable Water Evaporation with Salt Rejection

A PAM hydrogel surface-coated hydroponic bamboo evaporator with efficient thermal utilization for solar evaporation

Biomass-enhanced Janus sponge-like hydrogel with salt resistance and high strength for efficient solar desalination

Hierarchical Photothermal Fabrics with Low Evaporation Enthalpy as Heliotropic Evaporators for Efficient, Continuous, Salt-Free Desalination