Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

Low Noise Amplifier Design and Performance Analysis of RF Front-End for Narrow Band Receivers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Highly Linear 2.4GHz Low Noise Amplifier

5 GHz LNA based on CHRT 0.18 μm CMOS technology

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 2.4ghz Low Noise High Linearity RF Front-End Design.

0.6–3-Ghz Wideband Receiver RF Front-End with a Feedforward Noise and Distortion Cancellation Resistive-Feedback LNA

A dual band CMOS two-stage variable gain low noise amplifier

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

A High Gain Fully Integrated CMOS LNA for WLAN and Bluetooth Application

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

Design of an Ultra-Wideband CMOS Low Noise Amplifier