Abstract:The complex three-shaft three-reducer structural designs of helicopter transmission systems are prone to changes in the relative positions of shafting under the conditions of main rotor and tail rotor loads. These changes will affect the transmission characteristics of the entire transmission system. In this study, the planetary gear trains of helicopters were examined. Due to the fact that these structures are considered to be the most representative structures of the main reducers of helicopters, they were selected as the study objects for the purpose of examining the meshing characteristics of planetary gear trains when the relative positions of the shafting changed due to the position changes of the main rotor shafts under variable load conditions. It was found that by embedding the comprehensive time-varying meshing stiffness values of the main rotor shafts at different positions, a dynamic model of the relative position changes of the planetary gear trains could be established. Then, combined with the multibody dynamics software, the meshing characteristics of the sun gears, and the planetary gears, the planetary gears and the inner ring gears were simulated and analyzed under different inclinations and offsets of the shafting. The results obtained in this study revealed the following: (1) the average meshing force of the gears increased with the increases in the angle inclinations, and the meshing force between the sun gears and the planetary gears increased faster than the meshing force between the planetary gears and the inner ring gears. It was observed that during the changes in the shafting tilt positions, obvious side frequency signals had appeared around the peak of the meshing frequency in the spectrum. Then, with the continuous increases in the tilt position, the peak was gradually submerged; (2) the average meshing force of the gears increased with the increases in the offset, and the increasing trend of the meshing force between the sun gears and the planetary gears was similar to that observed between the planetary gears and the inner ring gears. It was found that when the shafting offset position changed, there were obvious first and second frequency doubling in the spectrum; (3) the mass center orbit radii of the sun gears increased with the increases in the shafting position changes, and the changes in the angular tilt position were found to have greater influencing effects on the mass center orbit radii of the sun gears than the changes in the offset positions. This study’s research findings will provide a theoretical basis for future operational status monitoring of the main transmission systems of helicopters and are of major significance for improvements in the operational stability of helicopter transmission systems, which will potentially ensure safe and efficient operations.

Characteristics analysis of the new flexible ring gear for helicopter reducer

Meshing characteristics and dynamic characteristics of planetary transmission system with new tooth-type flexible ring gear

Comprehensive Dynamic Model and Vibration Characteristics of Step-Type Compound Planetary Gear Sets

Simulation Analysis of a Novel Magnetic Gear

Study on Structural Vibration Characteristics of L-Shaped Flexible Ring Gear and Establishment of System Coupling Vibration Model

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Fault Characteristics Analysis of Planetary Gear of Helicopter Main Reducer

Study on nonlinear vibration and primary resonance characteristics of helicopter face gear-planetary gear coupling transmission system

An Analysis of the Gear Meshing Characteristics of the Main Planetary Gear Trains of Helicopters Undergoing Shafting Position Changes

Meshing principle and characteristics analysis of an abnormal cycloidal internal gear transmission

Analysis on the vibration reduction for a new rigid–flexible gear transmission system

Calculation Method of Dynamic Stress of Flexible Ring Gear and Dynamic Characteristics Analysis of Thin-Walled Ring Gear of Planetary Gear Train

The Analysis of the Flexible Load Sharing Structure of the Ring Gear in Planetary Transmission

The Analysis and Modeling of the Synthetical Meshing Stiffness of Inner Gearing considering the Flexible Inner Ring Gear

Dynamic modeling and analysis of high-speed flexible planetary gear transmission systems

Analysis of Inherent Characteristics of Two-Speed Planetary Gear Transmission System

Analytical investigation on load-sharing characteristics for multi-power face gear split flow system

Investigation of the Vibration Features and Dynamic Load Sharing Characteristics of Concentric Face Gear Torque Split Transmission

Study on dynamic characteristics of the gear-dual-rotor system with multi-position rubbing

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Vibration Characteristics of Rotor System Considering Gear Meshing