Abstract:Manufacturing defects are one of the main causes of internal short circuits (ISCs) and then lead to thermal runaway accidents of batteries, which seriously threatens the safety of electric vehicles. Cu particle contaminants are one of the most common and dangerous manufacturing defects. Cu particles that may cause ISC by dissolving on the cathode and precipitating on the anode are smaller in size and less likely to be detected during manufacturing, compared with those that cause ISC by directly piercing the separator. However, there is little research on the mechanism and evaluation of ISC caused by cathode Cu particle contaminants. In this paper, Cu particles were intentionally placed on the cathode of lithium-ion batteries (LIBs). The mechanism and type of ISC induced by the Cu dissolution-precipitation process in LIBs were successfully characterized for the first time, and the evolution process was concluded. The ISC introduced by Cu particles was successfully simulated by a pseudo three-dimensional model. And the size boundary of Cu particles causing ISC was also studied. It was found that the implanted Cu particles will necessarily cause ISC in the batteries. The key to the ISC caused by cathode Cu particles is the precipitation of Cu along the pores of the separator from the anode side to the cathode side. The type of ISC caused by this defect is a cathode-anode short circuit, which only induces a soft ISC. The maximum temperature of the battery with this defect can only increase by approximately 2 degrees C through the calculation of the model under the set conditions of this study, which would not cause thermal runaway of the battery. In addition, even when the size is as small as 20 mu m, the cathode Cu particle contaminants will still cause an ISC with short-circuit resistance of tens of k Omega magnitude. (C) 2022 Elsevier B.V. All rights reserved.

Mitigating internal short circuit in prismatic lithium‐ion battery pouch cell by using microstructured current collector

Effect of notch depth of modified current collector on internal-short-circuit mitigation for lithium-ion battery

Effect of groove width of modified current collector on internal short circuit of abused lithium-ion battery

Unveiling micro internal short circuit mechanism in a 60 Ah high-energy-density Li-ion pouch cell

A safety design strategy for practical lithium-ion pouch cells

Stretchable Separator/Current Collector Composite for Superior Battery Safety

Heterogeneous current collector in lithium-ion battery for thermal-runaway mitigation

Internal short circuit and dynamic response of large-format prismatic lithium-ion battery under mechanical abuse

Understanding of Stress‐Driven Internal Short Circuit Mechanisms in Lithium‐Ion Batteries with High SOCs

A Comprehensive Research on Internal Short Circuits Caused by Copper Particle Contaminants on Cathode in Lithium-Ion Batteries

Electrical and thermal interplay in lithium‐ion battery internal short circuit and safety protection

Draining Over Blocking: Nano‐Composite Janus Separators for Mitigating Internal Shorting of Lithium Batteries

Mechanism, modeling, detection, and prevention of the internal short circuit in lithium-ion batteries: Recent advances and perspectives

A Lightweight Carbon-Incorporated Polymer Current Collector for Improving the Performance and Safety of Lithium-Ion Batteries

Early Braking of Overwarmed Lithium-Ion Batteries by Shape-Memorized Current Collectors.

Polymer Based Multi-Layer Al Composite Current Collector Improves Battery Safety

Thermoexpandable Microsphere-Coated Al Foil Current Collector for Lithium-Ion Batteries with Improved Safety

Novel silica -coated cathode to realize internal-short-circuit proof, high-interface-stabilized, high-safety lithium batteries

Multi-layer Internal Short-Circuit Mechanism and Thermal Runaway Risk Assessment of Lithium-Ion Batteries Using Nail Penetration Simulation

Preventing thermal runaway propagation in lithium ion battery packs using a phase change composite material: An experimental study

Thermoregulating Separators Based on Phase‐Change Materials for Safe Lithium‐Ion Batteries