Abstract:This study is motivated by the need to develop an efficient numerical model to simulate non-uniform interfacial degradation of reinforcing steel in concrete in an accelerated corrosion setup. In this study, a multi physics finite element (FE) model is presented that takes into consideration the spatial and temporal non uniformity of corrosion induced degradation in rebar, and eliminates the assumption of uniform mass loss and its linear variation with time as per available literature that uses classical approach of Faraday's law. The model is validated experimentally with accelerated corrosion setup designed to induce partial corrosion. Further, the possibility of extending this model to monitor natural corrosion is discussed with required modifications. Unlike previous studies, pore saturation (PS) is continuously monitored and its existing experimental correlations with electrolyte conductivity and oxygen diffusivity in the vicinity of partial corrosion are adopted so that the model can be extended to simulate natural corrosion. These evaluations can be made completely nondestructive and in real time to capture the influence of local environment. The proposed methodology also captures the effect of differential aeration pertaining to local exposure. Therefore, the challenges in incorporating influence of local environment by the use of alternative parameters such as relative humidity from real climate change predictions are eliminated. It is shown that the multi-physics model is effective and convenient to simulate the non-uniform time dependent mass loss with acceptable accuracy and that its capability can be extended to monitor natural non uniform corrosion on a space time frame.

Performance assessment of cathodically protected reinforced concrete structure based on alternative performance criterion: a case study

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Computational Approach to the Current and Chloride Ions Distribution of Reinforced Concrete Cathodic Protection System

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

A Comparison Study on the Natural and Half-Soaking Galvanic Accelerated Corrosion of Reinforced Concrete Based on an Improved Electrochemical Model

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

Experimental Research on Performance of Anti-corrosion Coating Against Chloride Ion Ingress into Concrete

Corrosion Prediction Models for Steel Bars in Chloride-Contaminated Concrete: a Review

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

Mechanical Performance of Corroded Steel Bars in Concrete

Analytical Review of Conductive Coatings, Cathodic Protection, and Concrete

Efficiency of the Impressed Current Cathodic Protection (ICCP) in reinforced concretes: Experimental and numerical investigation

Effectiveness of Multi-Physics Numerical Model in Simulating Accelerated Corrosion with Spatial and Temporal Non Uniformity

Data-driven Corrosion Failure Probabilistic Assessment Model for Reinforced Concrete Structures

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Pitting corrosion and stress corrosion cracking study in high strength steels in alkaline media

Improved Tafel-Based Potentiostatic Approach for Corrosion Rate Monitoring of Reinforcing Steel

Early stage beneficial effects of cathodic protection in concrete structures

Carbon enhanced cementitious coatings: Alternative anode materials for impressed current cathodic protection systems intended for reinforced concrete