Abstract:It is important to understand the process of multiphase carbon dioxide (CO2) leakage in faults for the risk assessment of carbon capture and storage (CCS). To quantitatively characterize the CO2 leakage process in the fault, pressure sensors, fiber Bragg grating (FBG) temperature and strain sensors were simultaneously used to monitor CO2 leakage in the fault. Ten experiments were carried out, including five groups of gaseous CO2 leakage tests with initial pressures of 1–5 MPa and five groups of liquid CO2 leakage tests with initial pressures of 6–10 MPa. The results indicate that when liquid CO2 leaked with an initial pressure of 7–10 MPa, the pressure and temperature of CO2 dropped rapidly in the first few seconds and then remained unchanged. The behavior that CO2 continues to leak while maintaining temperature and pressure unchanged is defined as “temporary pseudo-sealing (TPS)” behavior, which continues for the first 1/3 of the leakage period. However, this TPS behavior did not occur in gaseous CO2 leakage. If only the pressure and temperature data were used to evaluate whether CO2 leakage occurred, we would misjudge the risk of leakage in CCS projects during the TPS period. The causes and conditions of TPS behavior were further studied experimentally. The results show that: (1) TPS behavior is caused by the phase transition energy generated when liquid CO2 leaks. (2) The condition for TPS behavior is a small leak aperture (0.2 mm). Only a small leakage rate can make the phase transition energy and pressure change from a dynamic equilibrium, and (3) The compression zone caused by the Bernoulli effect and fault “barrier” could reduce the CO2 leakage rate and further promote the occurrence of TPS behavior. This study provides technical and theoretical support for the quantitative characterization of the CO2 leakage process in faults of CCS projects.

Classification and Characteristics of Supercritical Carbon Dioxide Leakage from a Vessel

The leakage behavior of supercritical CO 2 flow in an experimental pipeline system

An Experimental Investigation of Supercritical CO2 Accidental Release from a Pressurized Pipeline

Experimental and Numerical Investigation on the Dynamic Characteristics of a Lab-Scale Transcritical CO2 Loop

The Flow and Heat Transfer Characteristics of Supercritical CO2 Leakage from a Pipeline

Numerical Investigation of the Leakage Flow from a Pressurized CO2 Pipeline

Study on Measurement Accuracy of State Parameters in Leakage Process of Supercritical CO2 Pipeline

A study on decompression wave propagation characteristics during CO2 pipeline leakage with consideration of gas‐liquid transition

An experimental investigation on pressure response and phase transition of supercritical carbon dioxide releases from a small‐scale pipeline

Experimental Investigation of the Characteristics of Supercritical CO2 during the Venting Process

A Study of Small-Scale CO 2 Accidental Release in Near-Field from a Pressurized Pipeline

Characterization of carbon dioxide leakage process along faults in the laboratory

Prediction on Leakage and Rate Characteristics of CO2 Storage

An Experimental Study on the Leakage Process of High Pressure Co2 from A Pipeline Transport System

Phase change-induced internal-external strain of faults during supercritical CO 2 leakage

Analysis of Internal Corrosion of Supercritical CO2 Pipeline

Simulation study on near-field structure and flow characteristics of high-pressure CO<sub>2</sub> released from the pipeline

A Leakage Safety Discrimination Model and Method for Saline Aquifer CCS Based on Pressure Dynamics

A Modelling Study of the Multiphase Leakage Flow from Pressurised CO2 Pipeline.

Modeling of possible CO2 leakage with phase transition in wellbore-reservoir system based on the Ordos CCS project, China

Experiment on the medium volume fraction distribution and hazardous area in the case of CO2pipeline leakage