RESEARCH OF THE INTERNAL LEAKAGE PROCESS OF A LIQUID IN THE DESIGN OF A GEAR PUMP WITH A TWO-AXIAL CONNECTION

A. K. Sherov,D. E. Alikulov,Yu. M. Smirnov,K. T. Sherov,A. K. Rakishev,M. M. Mussayev,A. V. Mazdubay

DOI: https://doi.org/10.32014/2021.2518-170x.53

2021-04-15

SERIES OF GEOLOGY AND TECHNICAL SCIENCES

Abstract:This article presents the results of a study of the process of internal fluid leakage in the design of a gear pump with a biaxial connection. It is known that the volumetric efficiency mainly depends on the leakage of the working fluid through the gaps formed by the tooth heads and the pump casing, as well as between the end surfaces of the gears and the side walls of the casing. In addition, additional leaks occur along the contact line of the teeth. To reduce radial leaks, the gap between the gears and the pump casing is minimized, and to reduce end-leakage, the side walls are automatically pressed against the end surfaces of the gears by liquid under operating pressure. The design of the pump shows that the main internal fluid leaks occur in the gap between the gears and the housing. Naturally, these leaks require excessive energy consumption and, thereby, reduce the efficiency of the pump. The natural way to combat this circumstance is to reduce the marked gaps to a minimum. This is possible using an additional element - a biaxial sleeve. The dependence of the spring force on the fluid flow rate and the guaranteed gap between the ring gear and the pump casing has been analytically established. They are characterized by a drop in force with an increase in clearance and a rise in flow rate. This is due to an increase in the dynamic force in the gaps, which must be compensated by the spring.