Abstract:The geometric complexity and high-pressure gradients that characterize the design of the flow field of gear pumps make it very difficult to obtain an accurate CFD simulation of the component. Usually, assumptions are made both in terms of geometrical features and physics being included in the analysis. The contact between the teeth, which is a key factor for the correct functioning of these pumps, represents a critical challenge in 3D CFD simulations, mainly due to the intrinsic limits of the dynamic meshing techniques that can hardly effectively manage a zero or close to zero gap point forming during gear rotation. The geometric complexity and high-pressure gradients that characterize the gear pump flow field make a CFD analysis quite difficult, and the contact between the gear teeth is usually avoided, thus being an extremely important feature. In this paper, a gear pump composed of inlet and outlet pipes was considered, and the contact between the gear’s teeth was modeled in two different ways, one where it is effectively implemented and one where it is avoided using distancing and a proper casing modification. Herein, a new methodology is proposed for the application of the dynamic mesh method in the Simcenter STAR-CCM+ environment using an adaptive remeshing technique. The proposed methodology is compared with the alternative overset meshing method available in the software. The new meshing method is implemented using a user-routing that reproduces the real geometry of the gears while rotating during the pump operation, with teeth contact included. The routine is optimized in order to limit the additional computation and time needed for the remeshing process. The results that can be obtained using the two meshing approaches for the gear pump are compared in terms of computational effort and the accuracy of the results. The two methods showed opposite results in almost all the reported results, with the overset being more precise in the radial pressure evaluation and the dynamic being more reliable in the cavitation/aeration extension cloud.

Effect of cavitation on leakages through active contact of involute toothed external gear pump

Numerical Study of the Hydrodynamics of an External Gear Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Investigation of leakage within an external gear pump with new decompression slots: numerical and experimental study

Dynamic Simulation Research on Cavitation in Internal Multi-connected Volumes of Gear Pump

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Study of a High-Pressure External Gear Pump with a Computational Fluid Dynamic Modeling Approach

Analysis of axial leakage in high pressure involute internal gear pump

Fluid analysis of the cavitation of the microsegment gear pump operating at high-pressure condition

An Investigation of the Vibration Modes of an External Gear Pump through Experiments and Numerical Modeling

Experimentation and 2D Fluid Flow Simulation over an External Gear Pump

Study of the Cavitation Phenomenon Inside Roller Vane Pump

Research on Cavitation Characteristics and Influencing Factors of Herringbone Gear Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

A Two-Dimensional Numerical Analysis of a Circular-Arc Gear Pump Operating at High Pressures and High Speeds

The Study of Leakage of Circular Arc–involute–circular Arc Gear Pump

Numerical Modeling of a Helical External Gear Pump With Continuous-Contact Gear Profile: A Comparison Between a Lumped-Parameter and a 3D CFD Approach of Simulation

Numerical investigation of vibration-induced cavitation for gears considering thermal effect

A CFD study of an Electronic Hydraulic Power Steering Helical External Gear Pump: Model Development, Validation and Application

CFD Modeling and Experimental Validation of the Flow Processes of an External Gear Pump