Abstract:The geometric complexity and high-pressure gradients that characterize the design of the flow field of gear pumps make it very difficult to obtain an accurate CFD simulation of the component. Usually, assumptions are made both in terms of geometrical features and physics being included in the analysis. The contact between the teeth, which is a key factor for the correct functioning of these pumps, represents a critical challenge in 3D CFD simulations, mainly due to the intrinsic limits of the dynamic meshing techniques that can hardly effectively manage a zero or close to zero gap point forming during gear rotation. The geometric complexity and high-pressure gradients that characterize the gear pump flow field make a CFD analysis quite difficult, and the contact between the gear teeth is usually avoided, thus being an extremely important feature. In this paper, a gear pump composed of inlet and outlet pipes was considered, and the contact between the gear’s teeth was modeled in two different ways, one where it is effectively implemented and one where it is avoided using distancing and a proper casing modification. Herein, a new methodology is proposed for the application of the dynamic mesh method in the Simcenter STAR-CCM+ environment using an adaptive remeshing technique. The proposed methodology is compared with the alternative overset meshing method available in the software. The new meshing method is implemented using a user-routing that reproduces the real geometry of the gears while rotating during the pump operation, with teeth contact included. The routine is optimized in order to limit the additional computation and time needed for the remeshing process. The results that can be obtained using the two meshing approaches for the gear pump are compared in terms of computational effort and the accuracy of the results. The two methods showed opposite results in almost all the reported results, with the overset being more precise in the radial pressure evaluation and the dynamic being more reliable in the cavitation/aeration extension cloud.

Dynamic Simulation Research on Cavitation in Internal Multi-connected Volumes of Gear Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Numerical Study of the Hydrodynamics of an External Gear Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Study of the Cavitation Phenomenon Inside Roller Vane Pump

Fluid analysis of the cavitation of the microsegment gear pump operating at high-pressure condition

Numerical Simulation and Analysis of Cavitation Flows in a Double Suction Centrifugal Pump

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Centrifugal Effects on Cavitation in the Cylinder Chambers for High-Speed Axial Piston Pumps

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Research on Cavitation Characteristics and Influencing Factors of Herringbone Gear Pump

Liquid-vapor two-phase flow in centrifugal pump: Cavitation, mass transfer, and impeller structure optimization

Effect of cavitation on leakages through active contact of involute toothed external gear pump

Internal Flow and Cavitation Analysis of Scroll Oil Pump by CFD Method

Gaseous cavitation characteristics of high-speed hydraulic electric motor-pump based on centrifugal pressurization: A numerical study

The Simulation and Analysis of the Flow Field Inside Water Hydraulic External Gear Pump

Numerical Research on the Cavitation Characteristics for Typical Conditions of A Centrifugal Pump with Whole Flow Passage

Numerical Modeling of a Helical External Gear Pump With Continuous-Contact Gear Profile: A Comparison Between a Lumped-Parameter and a 3D CFD Approach of Simulation

Study of a High-Pressure External Gear Pump with a Computational Fluid Dynamic Modeling Approach