A strain rate dependent thermo-elasto-plastic constitutive model for crystalline metallic materials

Cen Chen,TzuChiang Wang

DOI: https://doi.org/10.1038/s41598-021-88333-1

IF: 4.6

2021-04-23

Scientific Reports

Abstract:Abstract The strain rate and temperature effects on the deformation behavior of crystalline metal materials have always been a research hotspot. In this paper, a strain rate dependent thermo-elasto-plastic constitutive model was established to investigate the deformation behavior of crystalline metal materials. Firstly, the deformation gradient was re-decomposed into three parts: thermal part, elastic part and plastic part. Then, the thermal strain was introduced into the total strain and the thermo-elastic constitutive equation was established. For the plastic behavior, a new relation between stress and plastic strain was proposed to describe the strain rate and temperature effects on the flow stress and work-hardening. The stress–strain curves were calculated over wide ranges of strain rates (10 –6 –6000 s −1 ) and temperatures (233–730 K) for three kinds of crystalline metal materials with different crystal structure: oxygen free high conductivity copper for face centered cubic metals, Tantalum for body centered cubic metals and Ti–6Al–4V alloy for two phase crystal metals. The comparisons between the calculation and experimental results reveal that the present model describes the deformation behavior of crystalline metal materials well. Also, it is concise and efficient for the practical application.

multidisciplinary sciences

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: to study the influence of strain rate and temperature on the deformation behavior of crystalline metal materials. In order to explore this problem in depth, the author established a strain - rate - dependent thermo - elastic - plastic constitutive model, aiming to describe the deformation behavior of crystalline metal materials under different strain rate and temperature conditions. Specifically, this model introduced the thermal strain part by re - decomposing the deformation gradient, established the thermo - elastic constitutive equation, and proposed a new relationship between stress and plastic strain to describe the influence of strain rate and temperature on the flow stress and work hardening.

This model pays special attention to the following points:
1. **Thermal expansion effect**: The influence of the free thermal expansion of the lattice on the total deformation process is considered, and the thermal strain is introduced into the total strain.
2. **Thermo - elastic constitutive equation**: The thermo - elastic constitutive equations for single - crystal and polycrystalline metals are established.
3. **Plastic behavior**: A new relationship between stress and plastic strain is proposed, which can describe the influence of strain rate and temperature on the flow stress and work hardening.

The author verified the validity of the model by calculating the stress - strain curves of three crystalline metal materials with different lattice structures (face - centered cubic metal copper, body - centered cubic metal tantalum, and two - phase crystalline metal Ti - 6Al - 4V alloy) at different strain rates (from 10^-6 s^-1 to 6000 s^-1) and temperatures (from 233 K to 730 K) and comparing them with the experimental results. The results show that this model can accurately describe the deformation behavior of these materials under different strain rate and temperature conditions, and has high universality and computational efficiency.