Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

Study of micro-dimples fabricated on alumina-based ceramics using micro-abrasive jet machining

Experimental Study of Micro Dimple Fabrication Based on Laser Shock Processing

Material response to particle impact during abrasive jet machining of alumina ceramics

Studies on Geometric Morphologies of Micro Dimples Fabricated by High Strain Rate Laser Shock Processing

Modeling and Simulation of Micro-Hole Fabrication on Brittle Material Using Abrasive Air Jet Machining

Dimple Patterns Design for Different Circumstances

Fabrication and tribological characterization of laser textured engineering ceramics: Si3N4, SiC and ZrO2

Material removal mechanisms of ceramics turned by abrasive waterjet (AWJ) using a novel approach

Micromachining Porous Alumina Ceramic for High Quality Trimming of Turbine Blade Cores Via Double Femtosecond Laser Scanning

Fabrication of Dimples by Jet-ECM of Zr-Based Bulk Metallic Glasses with NaCl-Ethylene Glycol Electrolyte

Study on the fabrication of micro-textured end face in one-dimensional ultrasonic vibration–assisted turning

An experimental study on a rapid micro imprinting process

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Effect of Micro-Dimple Geometry on the Tribological Characteristics of Textured Surfaces

Experimental and numerical investigations into the fabrication of alumina ceramic surface microchannel by electrochemical discharge machining

The mechanisms of high-efficiency grinding for micro/meso-structural arrays on ceramic moulds through an innovative wheel truing technology

Micro dimple fabrication on OFHC copper by Laser shock processing

Material removal modes and processing mechanism in microultrasonic machining of ball ceramic tool

Characteristics of multiphase jet machining: A comparison with the absence of water

Micromilling of high-aspect-ratio ceramic thin walls with customized micro PCD end mills

Reduction of Friction Using Microabrasive Air Jet Machining