Abstract:Relevance. The choice of adequate models of materials and deformation diagrams is of great importance when performing structural calculations in a nonlinear setting. Since there are no instructions on how to use the deformation diagrams of concrete and reinforcement when working together, given in SP 63.13330.2018, it is necessary to introduce assumptions for modeling reinforced concrete structures with finite elements of the same type. The aims of the work are to conduct numerical experiments on testing concrete cylinders for uniaxial compression and to verify the results with normative data. Methods. Numerical experiments were performed in the LS-DYNA software package. This program complex allows to simulate the joint work of concrete and reinforcement with the help of volume (for concrete) and rod (for reinforcement) finite elements. A cylinder with a diameter of 150 mm and a height of 300 mm was taken as model. Samples were modeled by volumetric finite elements. The CSCM - Continuous Surface Cap Model is a nonlinear material used to model concrete. Tests were carried out with samples of the following classes of concrete for cylindrical compressive strength: C12, C16, C20, C25, C30, C35, C40, C45, C50, C55. This corresponds to the following classes of cubic compressive strength: B15, B20, B25, B30, B37, B45, B50, B55, B60, B67. Results. The conducted researches have shown that the character of destruction of samples at numerical experiment corresponds to the character of destruction at tests. The investigated concrete model CSCM can be used in the calculation of concrete and reinforced concrete structures for the main classes of concrete, when taking into account the transition from cubic to prismatic strength and additional correction factors to cylindrical strength.

A numerical approach to the complete stress-strain curve of concrete

Analysis-oriented Stress–strain Models for FRP–confined Concrete

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

STUDY OF BEARING CAPACITY AND COMPLETE STRESS-STAIN CURVES FOR CONCRETE FILLED SQUARE STEEL TUBE COLUMNS

Stress-Strain Behaviour Of Frp-Confined Concrete Subjected To Eccentric Compression

Flexural-Shear Behavior of High-Strength Concrete Short Columns

Equation for stress-strain curve of concrete confined in circular steel spiral

Effect of freeze–thaw cycles on the stress–strain curves of unconfined and confined concrete

STRESS-STRAIN STATE OF BENT REINFORCED CONCRETE ELEMENTS OF CONTINUOUS AND COMPOSITE CROSS-SECTION BASED ON A REFINED NONLINEAR CALCULATION METHOD

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Numerical Analysis of Softening Relationship for Early-Age Concrete

Failure criterion for concrete under volumetric stress state conditions

Numerical studies of strength of concrete cylinders for compression

A New Experimental Method of Concrete Complete Direct Tensile Stress-strain Curve

Stress–strain constitutive equations of concrete material at elevated temperatures

Concrete Constitutive Relationships Under Different Stress-Temperature Paths

Modeling for complete stress-strain curve of circular concrete columns confined with steel spiral and FRP

Application of a Nonlinear Deformation Model to the Analysis of Complete Moment-Curvature Diagrams of Reinforced Concrete Elements with Reinforcement A500

STRESS-STRAIN RELATION OF FRP-CONFINED CONCRETE

Influence of Initial Static Stress on the Dynamic Properties of Concrete

Size-dependent Nonlinear Post-Peak Stress-Strain Curve of Normal Concrete in Uniaxial Compression