Abstract:Background The determination of the maxillary occlusal plane presents a significant clinical challenge in the treatment of edentulous patients as well as it is critical for complex full‐mouth reconstructions in dentate patients, including those with implant‐supported rehabilitations. While the use of a Fox plane plate is standard in edentulous cases, its application in dentate patients lacks thorough documentation in existing literature. Purpose This clinical study assessed the sagittal position of the maxillary dentition in relation to facial landmarks using a digital three‐dimensional analysis and evaluated the suitability and reliability of applying a simulated Fox plane plate, also known as an occlusal plane guide, in dentate patients. Materials and Methods Eighty‐one subjects were recruited at the Department of Prosthetic Dentistry of Goethe University Frankfurt, Germany, according to specific inclusion criteria. Intraoral and facial scans were obtained and analyzed using GOM Inspect Pro software (GOM, Braunschweig, Germany). The angles between the maxillary occlusal plane and three variations each of Camper's plane and ala‐tragus line, relating to superior, middle, and inferior tragus points, were measured. These modified planes were then compared to a plane established by a simulated digital Fox plane plate, which was adapted to the maxillary anterior teeth and the lowest point of the posterior teeth in both quadrants. Results A total of 81 subjects (58 female and 23 male) with a mean age of 23.9 years were evaluated in this study. No significant angular difference was found between the angles of the maxillary occlusal plane compared with superior Camper's plane, middle Camper's plane, or superior ala‐tragus line (p >0.05). The smallest angle occurred between superior Camper's plane and the maxillary occlusal plane on both the right (3.443°) and left (3.535°) sides. The application of a Fox plane plate resulted in two different occlusal planes in 70% of patients, significantly deviating from the digitally determined plane (p <0.05). Conclusion Superior and middle Camper's planes, along with superior ala‐tragus line, can be considered approximately parallel reference planes and are suitable for routine determining of the maxillary occlusal plane in restorative treatments. However, in contrast to digital evaluation methods, the application of a Fox plane plate in dentate patients showed high variability, indicating its low reproducibility due to its ambiguous positioning on the maxillary dentition. Clinical trial registration site: https://drks.de/search/de/trial/DRKS00030166.

Evaluation of the posterior reference point of ala tragus line in relation to occlusal plane and Frankfort horizontal plane through cephalometry in Sangareddy (Telangana) population

An Analysis of Relation Among Three Levels of Ala-Tragus Line and Natural Occlusal Plane in Young Dentulous Subjects - A Cross-sectional Photographic Study

Relationship between the occlusal plane and three different levels of ala-tragus line in a sample of Sudanese adults

Evaluating the relation of posterior occlusal plane to ala-tragal line according to age and sex.

Assessment of Most Definite Reference Point on Tragus to Mark the Ala Tragus Line for Orientation of Occlusal Plane: A Systematic Review and Meta Analysis

Variations of the Ala-Tragal Plane to Occlusal Plane in Three Different Skeletal Jaw Relations in Dentate Subjects Using Digital Cephalometric Analysis an In vivo Study

Correlation of “K” plane to occlusal plane and three different ala-tragal lines in dentulous subjects with different skeletal forms: A cephalometric study

3D evaluation of sagittal inclination of the maxillary dentition in relation to facial landmarks: A cohort study

Comparison of Sagittal Condylar Guidance Angle Obtained by Radiographic Methods and Manual Programming of Articulators in Dentate Patients - A Clinico-radiographic Study

Analysis of the distance between lingual frenal attachment and mandibular incisal edge position in establishing occlusal plane in three different races

Evaluation of sagittal inclination of occlusal plane and horizontal condylar guidance using various anterior reference points on arcon and nonarcon articulators

Accuracy of Mandibular Foramen Localization Using Digital Orthopantomogram (OPG) in Middle Eastern Population

RELATIONSHIP OF ANTERIOR AND POSTERIOR OCCLUSAL PLANES WITH DIFFERENT SAGITTAL AND VERTICAL PATTERNS IN ADULTS

Association of anterior and posterior occlusal planes with different Angle and skeletal classes in permanent dentitions

Selection of a horizontal reference plane in 3D evaluation: Identifying facial asymmetry and occlusal cant in orthognathic surgery planning

Comparative evaluation of condylar inclination in dentulous subjects as determined by two radiographic methods: Orthopantomograph and cone-beam computed tomography - An in vivo study

A cephalometric study to ascertain the use of nasion as a guide in locating the position of orbitale as an anterior reference point among a population of South Coastal Karnataka

Evaluation of Lingual Foramen in the South Indian Population Using Cone-Beam Computed Tomography: A Prospective Cross-Sectional Study

Comparative evaluation of sagittal condylar guidance obtained from a clinical method and with cone beam computed tomography in dentate individuals

ACCURACY OF BROADRICK FLAG OCCLUSAL PLANE ANALYZER UTILIZING TWO DIFFERENT POSTERIOR SURVEY POINTS

Sagittal Cephalometric Evaluation Without Point Nasion: Sagittal G-Triangle Analysis