Abstract:Background The determination of the maxillary occlusal plane presents a significant clinical challenge in the treatment of edentulous patients as well as it is critical for complex full‐mouth reconstructions in dentate patients, including those with implant‐supported rehabilitations. While the use of a Fox plane plate is standard in edentulous cases, its application in dentate patients lacks thorough documentation in existing literature. Purpose This clinical study assessed the sagittal position of the maxillary dentition in relation to facial landmarks using a digital three‐dimensional analysis and evaluated the suitability and reliability of applying a simulated Fox plane plate, also known as an occlusal plane guide, in dentate patients. Materials and Methods Eighty‐one subjects were recruited at the Department of Prosthetic Dentistry of Goethe University Frankfurt, Germany, according to specific inclusion criteria. Intraoral and facial scans were obtained and analyzed using GOM Inspect Pro software (GOM, Braunschweig, Germany). The angles between the maxillary occlusal plane and three variations each of Camper's plane and ala‐tragus line, relating to superior, middle, and inferior tragus points, were measured. These modified planes were then compared to a plane established by a simulated digital Fox plane plate, which was adapted to the maxillary anterior teeth and the lowest point of the posterior teeth in both quadrants. Results A total of 81 subjects (58 female and 23 male) with a mean age of 23.9 years were evaluated in this study. No significant angular difference was found between the angles of the maxillary occlusal plane compared with superior Camper's plane, middle Camper's plane, or superior ala‐tragus line (p >0.05). The smallest angle occurred between superior Camper's plane and the maxillary occlusal plane on both the right (3.443°) and left (3.535°) sides. The application of a Fox plane plate resulted in two different occlusal planes in 70% of patients, significantly deviating from the digitally determined plane (p <0.05). Conclusion Superior and middle Camper's planes, along with superior ala‐tragus line, can be considered approximately parallel reference planes and are suitable for routine determining of the maxillary occlusal plane in restorative treatments. However, in contrast to digital evaluation methods, the application of a Fox plane plate in dentate patients showed high variability, indicating its low reproducibility due to its ambiguous positioning on the maxillary dentition. Clinical trial registration site: https://drks.de/search/de/trial/DRKS00030166.

Relationship between the occlusal plane and three different levels of ala-tragus line in a sample of Sudanese adults

An Analysis of Relation Among Three Levels of Ala-Tragus Line and Natural Occlusal Plane in Young Dentulous Subjects - A Cross-sectional Photographic Study

Variations of the Ala-Tragal Plane to Occlusal Plane in Three Different Skeletal Jaw Relations in Dentate Subjects Using Digital Cephalometric Analysis an In vivo Study

Evaluation of the posterior reference point of ala tragus line in relation to occlusal plane and Frankfort horizontal plane through cephalometry in Sangareddy (Telangana) population

Evaluating the relation of posterior occlusal plane to ala-tragal line according to age and sex.

Correlation of “K” plane to occlusal plane and three different ala-tragal lines in dentulous subjects with different skeletal forms: A cephalometric study

Study of the relationship between facial anatomical marking points and occlusal vertical dimension

Assessment of Most Definite Reference Point on Tragus to Mark the Ala Tragus Line for Orientation of Occlusal Plane: A Systematic Review and Meta Analysis

Analysis of the distance between lingual frenal attachment and mandibular incisal edge position in establishing occlusal plane in three different races

RELATIONSHIP OF ANTERIOR AND POSTERIOR OCCLUSAL PLANES WITH DIFFERENT SAGITTAL AND VERTICAL PATTERNS IN ADULTS

An Analysis of the Esthetic Proportions of Anterior Maxillary Teeth in a School of Dentistry in Ar Rass

Effect of patient’s age in the occlusal plane determinates by intra-oral landmarks in complete dentures

The accuracy of anatomic landmarks on the occlusal plane: a comparative study between conventional and 3D image method

3D evaluation of sagittal inclination of the maxillary dentition in relation to facial landmarks: A cohort study

Association of anterior and posterior occlusal planes with different Angle and skeletal classes in permanent dentitions

Association of Anterior and Posterior occlusal planes with skeletal class I, class II and class III malocclusion

Layperson's Preference Regarding Orientation of Transverse Occlusal Plane from the Frontal Perspective in Fabrication of a Complete Denture: A Cross-sectional Study

[Reliability Evaluation for Thirteen Parameters Describing Anteroposterior Apical Base Relationship in Angle Class II Division 1 Patients].

Position of Fovea Palatinae relative to the vibrating line in various soft palate classifications among Jordanian edentulous population

The Association between Skeletal Protrusion and Labiolingual Inclination of Teeth with Anterior Alveolar Bone Thickness by Computed Beam Computed Tomography Images

Accuracy of Mandibular Foramen Localization Using Digital Orthopantomogram (OPG) in Middle Eastern Population