Abstract:In this work, we study the deformation behavior of thin films of various soft glassy materials that are simultaneously subjected to two creep flow fields, rotational shear flow by applying torque and elongational flow by applying normal force. The generic behavior under the combined fields is investigated in different soft glassy materials with diverse microstructure such as: hair gel, emulsion paint, shaving foam and clay suspension. Increase in strength of one stress component while keeping the other constant, not only leads to an expected enhanced deformation in its own direction, but also greater strain in the other direction. Herschel Bulkley model is observed to explain this behavior qualitatively. Elongational flow induced in the materials eventually causes failure in the same. Interestingly time to failure is observed to be strongly dependent not just on normal force but also on the applied rotational shear stress. We believe that the presence of a three dimensional jammed structure, in which overall unjamming can be induced by applying stress having sufficient magnitude irrespective of the direction leads to the observed behavior. In addition, we observe self-similarity in the elongational as well as rotational strain time curves corresponding to various combinations of both the fields. This observation suggests a mere shift in the time-scales involved keeping the path followed in the process unchanged. A phase diagram is also constructed for various soft glassy materials by determining different combinations of orthogonal stresses beyond which materials yield. Estimated yield stress in the limit of flow dominated by applied tensile force on the top plate demonstrates scatter, which might be originating from fingering instability. Except this deviation, yielding is observed when the invariant of stress tensor exceeds yield stress, validating the Von Mises criterion.

Large strain time dependent behavior of cheese

A Finite Deformation Fractional Viscoplastic Model for the Glass Transition Behavior of Amorphous Polymers

Constitutive Modeling of Nonlinear Strain and Time Dependent Behaviors of Ballistic Gelatin at Low Strain Rates

Modelling of dynamic mastication physics of cheese/casein gels as function of milk-fat distribution and intensity of thermo-mechanical treatment

Identification of factors affecting wear behavior of semi-hard cheeses

An elastic-viscoplastic model for large deformation

The Uniaxial Stress–Strain Relationship of Hyperelastic Material Models of Rubber Cracks in the Platens of Papermaking Machines Based on Nonlinear Strain and Stress Measurements with the Finite Element Method

Analysis of Size Effects Based on A Symmetric Lower-Order Gradient Plasticity Model

Modeling Long-Term Creep and Physical Aging Behavior of Carbon/Epoxy Composites Based on Coupling Model

Predicting and assessing rupture in protein gels under oscillatory shear

The nonlinear time-dependent response of isotactic polypropylene

Large deformation modeling of flexible piezoelectric materials

Nonlinear Viscoelasticity and Generalized Failure Criterion for Polymer Gels

Large Strain Viscoelastic Constitutive Models for Rubber, Part II: Determination of Material Constants

Fully non-linear hyper-viscoelastic modeling of skeletal muscle in compression

Two Possible Defect Growth Modes in Soft Solids

Stress and Strain Characteristics under the Large Deformation of Surimi Gel during Penetration and Extension Tests Using Digital Image Correlation and the Numerical Simulation Method

Nonlinear elasticity of disordered fiber networks

Modeling Analysis of Complex Deformation of Woven Coating Film during the Cyclic Tensile Process

Shear Mediated Elongational Flow and Yielding in Soft Glassy Materials

A Burger Model for the Effective Behavior of a Microcracked Viscoelastic Solid