Abstract:In order to study the influence of mechanical constraints and thermal state on thermoelastic contact nonlinear problem that between cylinder head and cylinder head gasket, a four-body contact simplified model of cylinder head-cylinder head gasket-engine block-bolts was built based on a four-valve diesel engine.Under different bolt preload and thermal state, contact state and deformation of cylinder head plate were calculated by using Augmented Lagrange multipliers as the contact algorithm.Then the influence of contact stresses and nodal displacements of mechanical constraints on some parts of the cylinder head plate were revealed in rated thermal state condition.Moreover the effect of different thermal state on the results was similarly revealed.The study makes clear that, when preload maintains the rated value and burst pressure is exerted, contact stresses in rated thermal state condition of the parts on cylinder head plate that against the cylinder ring and around the screw, which is on exhaust valve side, are similar with those values in cold state, while nodal displacements are reduced, and in different thermal states, the rates of change among the nodal displacements around the screw and both contact stresses and nodal displacements that against the cylinder ring are all less than 2%;with few exceptions, contact stresses and nodal displacements of these parts of the cylinder head plate increase with the increases of the bolt preload.The results also show that cylinder head gasket sealing tests in normal temperature condition is roughly adequate to practical state.

Combined multi-body dynamics and experimental investigation for determination of the cam-flat tappet contact condition

Impact of the Piston Secondary Motion on Its Slap Force

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Finite-element analysis of contact characteristics and friction modes of the "valve-guide" of the internal combustion engine

Coupling Simulation Between Tribology and Dynamic of Flexible Multi-Body of Piston Crankshaft System

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

A Review of Dynamic-Tribological Simulation Methods for Sliding Bearings in Internal Combustion Engines

Normal Load of Internal Combustion Engine Junction Based on Fractal Theory of Thermal Elasto-Plastic Contact

Study on Thermoelastic Contact of Cylinder Head-Cylinder Head Gasket-Engine Block

Dynamics and lubrication analyses of a planar multibody system with multiple lubricated joints

Investigation of the lubrication performance of a marine diesel engine crankshaft using a thermo-electrohydrodynamic model

Research on Fatigue and Transient Dynamic Analysis of Camshaft

Multi-body dynamics and finite element method co-simulation for crankshaft dynamical strength analysis

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

Engine Multi-Body with Flexible Crankshaft Modeling and Numerical Simulation

Simulation and Experimental Research on Piston Secondary Motion

Study of the effect of contact force model on the dynamic response of mechanical systems with dry clearance joints: computational and experimental approaches

Analysis of friction in surface textured components of reciprocating mechanism

Surface texture and heat treatment on the friction performance of cam tappet experimental and fluid-solid coupling numerical study