Abstract:The performance of reciprocating friction pairs in low-speed marine diesel engines has an important impact on the economy, stability, and safety of the ship operation, which deserves special attention. However, the available research is very limited. In this article, a new tribodynamics modeling method and an online measurement method for friction force are proposed. The friction force is simulated and verified by experiments. Based on the principle of multibody dynamics and mixed lubrication theory, a tribodynamic model coupling the reciprocating friction pairs (piston assembly-cylinder liner, piston rod-stuffing box, and crosshead slipper-guide) is first established. The friction force and dynamics are theoretically analyzed. Then a friction measurement method, which can measure the friction force of reciprocating friction pairs under engine firing conditions, is developed and used to verify the simulation. By comparison, it is found that the simulated friction is in good agreement with the experimental one. The results show that the crosshead slipper and piston assembly have obvious secondary motion, which will affect the vibration and noise of the engine. The friction force of the piston assembly is much higher than that of other reciprocating friction pairs. Improving the lubrication state near the top dead center of the piston assembly is of great significance to reduce the friction loss of the low-speed marine engines.

Investigation of the lubrication performance of a marine diesel engine crankshaft using a thermo-electrohydrodynamic model

Crosshead Bearing Analysis For Low-Speed Marine Diesel Engines Based On A Multi-Body Tribo-Dynamic Model

Mixed Thermo-Elasto-hydrodynamic Lubrication and Wear Coupling Simulation Analysis for Dynamical Load Journal Bearings

Engine Multi-Body with Flexible Crankshaft Modeling and Numerical Simulation

A new tribo-dynamics modeling and online measurement method for crosshead bearings in marine engines

A new comprehensive tribo-dynamic analysis for lubricated translational joints in low-speed two-stroke marine engines

Evaluation of lubrication performance of crank pin bearing in a marine diesel engine

FLEXIBLE MULTIBODY DYNAMICS SIMULATION OF DIESEL ENGINE CRANKSHAFT BASED ON ABSOLUTE NODAL COORDINATES

Lubrication characteristics study of main bearings on crankshaft balance rate

Lubricating Simulation Analysis of Connecting Rod Bearing Based on AVL-EXCITE

An Improved TEHL Model for Main Bearings of IC Engine with Flexible Crankshaft and Block

Crankshaft Transient Motion Analysis for Marine Diesel Engine

A new coupling tribodynamic model of crosshead slipper-guide system and piston skirt-liner system of low-speed marine diesel engines

Dynamic simulation research on diesel engine's cranktrain and block

Dynamics and lubrication analyses of a planar multibody system with multiple lubricated joints

Simulation Analysis and Experimental Verification of Tribodynamics of Reciprocating Friction Pairs in Low-Speed Marine Engines

Research on the thermohydrodynamic lubrication performance of engine main bearing with rough surface considering the axial motion and deformation of crankshaft

Multi-body dynamics and finite element method co-simulation for crankshaft dynamical strength analysis

Study on Coupling System Dynamical Behavior to Hydrodynamic Lubrication in Internal-Combustion Engine

Investigation on Lubrication Characteristics of Main Bearings in Gasoliine Engine Based on Multi-Body Dynamic and Kriging Modeling

The Analysis of Lubrication Properties of Crankshaft Main Bearing on Diesel Engine