Abstract:The cracking behavior greatly influences the material removal and surface integrity during the abrasive machining of brittle materials. The abrasive machining can be simplified as a series of scratching by different-shaped indenters. In this paper, a scratch-induced stress field model is built to analyze the cracking behavior during scratching brittle materials. The model considers conical, pyramidal, and spherical (CPS) indenters and correlates the scratch-induced principal stress with workpiece material properties, indenter geometries, and scratch behavior parameters (e.g., scratch normal load, tangential load, friction coefficient, scratch depth). With the model, the effects of scratch depth and indenter geometries on the scratch behavior and cracking behavior are investigated. The results show that the scratch load decreases when a sharper indenter or a spherical indenter with a smaller radius is used. The larger the scratch depth, the easier it is for radial, median, and lateral (RML) cracks to initiate. There is an optimal indenter half-apex angle at which it is most difficult to initiate radial and median cracks. The lateral crack easily initiates when the indenter becomes sharp. The initiation position of radial crack changes from being in front of the indenter to being behind it as the scratch depth increases or the half-apex angle decreases. The propagation angle of radial crack decreases, while that of median crack increases with an increase in scratch depth. The sizes of RML cracks increase with an increasing scratch depth or half-apex angle. Finally, the model is validated through scratching experiments on fused silica using CPS indenters and by referencing previous research. It demonstrates that the model can accurately determine the sizes of RML cracks, with an average relative error of less than 11%. This research provides guidance on selecting suitable process parameters or indenter geometries to increase the material removal rate and mitigate the crack damage during the abrasive machining of brittle materials.

Numerical analysis of the cutting interaction between indenters acting on disordered materials

Multiscale Simulation Of Wedge Nanoindentation Based On The Repulsive Force-Field Approach

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Discrete element modeling of tool‐rock interaction I: rock cutting

Cracking behavior during scratching brittle materials with different-shaped indenters

The Effect of Indenter Angle on the Microindentation Hardness

A coupled approach to predict cone-cracks in spherical indentation tests with smooth or rough indenters

Friction Effect on Micro-indentation Measurement with Different Indenters

Towards understanding the influence of structured indenters geometry on material deformation behavior of indentation process

Integrated Simulation, Machine Learning, and Experimental Approach to Characterizing Fracture Instability in Indentation Pillar-Splitting of Materials

Study of Effect of Indenter Shape in Nanometric Scratching Process Using Molecular Dynamics

Numerical and Experimental Study of the Roughness Effects on Mechanical Properties of AISI316L by Nanoindentation

Friction Behavior in Nanoscratching of Reaction Bonded Silicon Carbide Ceramic with Berkovich and Sphere Indenters

Numerical study of microstructural effects on chip formation in high speed cutting of ductile iron with discrete element method

Micromechanics of machining and wear in hard and brittle materials

Indenter Geometrical Effects on Sub-Micro/Nano Indentation and Scratch Behaviors of Polymeric Surfaces

Microstructure evolution modeling of Ti6Al4V alloy during cutting using the Particle Finite Element Method and homogeneous field distributions

Investigations on Brittle-Ductile Cutting Transition and Crack Formation in Diamond Cutting of Mono-Crystalline Silicon

Modeling Effect of Surface Roughness on Nanoindentation Tests

Numerical Assessment of Transition in Cutting Mode and Its Effect on Roughness Creation