Abstract:Miniaturization of gas chromatography (GC) instrumentation is of interest because it addresses current and future issues relating to compactness, portability and field application. While incremental advancements continue to be reported in GC with columns fabricated in microchips (referred to in this paper as "microchip columns"), the current performance is far from acceptable. This lower performance compared to conventional GC is due to factors such as pooling of the stationary phase in corners of non-cylindrical channels, adsorption of sensitive compounds on incompletely deactivated surfaces, shorter column lengths and less than optimum interfacing to injector and detector. In this work, a GC system utilizing microchip columns was developed that solves the latter challenge, i.e., microchip interfacing to injector and detector. A microchip compression clamp was constructed to heat the microchip (i.e., primary heater), and seal the injector and detector fused silica interface tubing to the inlet and outlet ports of the microchip channels with minimum extra-column dead volume. This clamp allowed occasional operation up to 375°C and routine operation up to 300°C. The compression clamp was constructed of a low expansion alloy, Kovar™, to minimize leaking due to thermal expansion mismatch at the interface during repeated thermal cycling, and it was tested over several months for more than one hundred injections without forming leaks. A 5.9m long microcolumn with rectangular cross section of 158μm×80μm, which approximately matches a 100μm i.d. cylindrical fused silica column, was fabricated in a silicon wafer using deep reactive ion etching (DRIE) and high temperature fusion bonding; finally, the channel was coated statically with a 1% vinyl, 5% phenyl, 94% methylpolysiloxane stationary phase. High temperature separations of C10-C40 n-alkanes and a commercial diesel sample were demonstrated using the system under both temperature programmed GC (TPGC) and thermal gradient GC (TGGC) conditions. TGGC analysis of a complex essential oil sample was also demonstrated. Addition of a secondary heater and polyimide insulation proved to be helpful in achieving the desired elution temperature without having to raise the primary heater temperature above 300°C for high boiling point compounds.

Fabrication of micro-gas chromatograph columns for fast chromatography

Design, Fabrication, and Evaluation of Microfabricated Columns for Gas Chromatography

A microchip gas chromatography column assembly with a 3D metal printing micro column oven and a flexible stainless-steel column

Progressive Cellular Architecture in Microscale Gas Chromatography for Broad Chemical Analyses

Extending the upper temperature range of gas chromatography with all-silicon microchip columns using a heater/clamp assembly

A Portable Micro-Gas Chromatography with Integrated Photonic Crystal Slab Sensors on Chip

Microchip Gas Chromatography Column Using Magnetic Beads Coated with Polydimethylsiloxane and Metal Organic Frameworks

Microfabricated planar glass gas chromatography with photoionization detection

Microfluidic integration of μPID on μcolumn for ultracompact micro-gas chromatography

Micro gas chromatography sample injector for the analysis of natural gas

High-performance MEMS-based gas chromatography column with integrated micro heater

A Micro Gas Chromatography with Separation Capability Enhanced by Polydimethylsiloxane Stationary Phase Functionalized by Carbon Nanotubes and Graphene.

A fully electronic microfabricated gas chromatograph with complementary capacitive detectors for indoor pollutants

MEMS-based Sensing Technology for the Gas Chromatograph Analysis

Sample introduction in high speed capillary gas chromatography; input band width and detection limits

Material Characterization Using a Tandem Micro-Reactor – GC–MS

A Graphitized-Carbon Monolithic Column

A Binder Jet Printed, Stainless Steel Preconcentrator as an In-Line Injector of Volatile Organic Compounds

Real-Time Simultaneous Separation and Detection of Chemicals Using Integrated Microcolumn and Surface Plasmon Resonance Imaging Micro-GC

Mass Fabrication of Capillary Columns Based on Centrifugal Packing

Compact, Automated, Inexpensive, and Field-Deployable Vacuum-Outlet Gas Chromatograph for Trace-Concentration Gas-Phase Organic Compounds