Abstract:(Pbx,Sr1−x )0.85Bi0.1TiO3 thin films with the perovskite phase structure were prepared on an ITO glass substrate by sol-gel method. X-ray diffraction (XRD), scanning electron microscopy (SEM) and an impedance analyzer were respectively used in order to characterize the phase status, morphology and dielectric properties of the thin films. The results show that during the formation process of (Pbx,Sr1−x )0.85Bi0.1TiO3 thin films, the nucleus of the perovskite phase are initially formed and then congregated. These aggregated nucleus are then transformed as the perovskite-phase crystalline in the thin film. Finally, the crystalline phase grows and separates gradually to form the perfect crystalline-phase structure. The content of the perovskite phase formed in the thin film under rapid thermal process (RTP) is more than that formed under traditional heat treatment with kinetic equilibrium. This is due to the high active decomposed ions that form the perovskite phase directly when heat-treated by RTP. The formation of the perovskite phase therefore overcomes a much lower barrier under RTP than that under traditional calcinations. The structure of the perovskite phase has a close relation to the ratio of Pb/Sr in the system because of the radius difference between Pb2+ and Sr2+. The transformation temperature between the cubic and the tetragonal structures of the perovskite phase increases with increasing Pb2+ content because the radius of Pb2+ is larger than that of Sr2+. It appears at room temperature when the content of Pb2+/Sr2+ is about 40/60 in the thin film. Meanwhile, the tetragonality of the perovskite phase is increased when Pb2+ ions increase due to its high polarization. The higher tunability of the (Pbx,Sr1−x )0.85Bi0.1TiO3 thin film is exhibited when the film composition is close to the transformation point between the paraelectric and ferroelectric phases. Pb2+ ions show a dominant factor to affect the Curie point of the system and then changing tunability.

Strontium-modified lead zirconate titanate thin films for electrically tunable device applications

The Roles of B-Site Ions in Lead Strontium Zirconate Titanate Thin Films for Electrically Tunable Device Applications

Structure and Tuning Properties of Sol–gel-Derived Pb0.4Sr0.6Zr0.52Ti0.48O3 (PSZT) Thin Films

Crystallographic Orientation Dependence of Dielectric Response in Lead Strontium Titanate Thin Films

Preparation of (1− x %)(Na 0.5 Bi 0.5 )TiO 3 – x %SrTiO 3 thin films by a sol–gel method for dielectric tunable applications

Effect of La Doping on Tunable Behavior of Sol–gel-Derived PST Thin Film

Preparation of (1− <i>x</i> %)(Na<sub>0.5</sub>Bi<sub>0.5</sub>)TiO<sub>3</sub>– <i>x</i> %SrTiO<sub>3</sub> thin films by a sol–gel method for dielectric tunable applications

Tunable dielectric properties of sol–gel derived (Pb0.35, Sr0.65) (Zr0.5, Ti0.5)O3 thin films for microwave application

Enhanced Tunability Performance of Low Temperature Crystallized Pb0.4sr0.6tio3 Thin Films Derived from Distinct Microstructure

Effects of the Substitution of Pb for Ba in (ba,sr)tio3 Films on the Temperature Stability of the Tunable Properties

Effect of lead on formation and dielectric tunability of (Pb<sub>x</sub>,Sr<sub>1− <i>x</i> </sub>)<sub>0.85</sub>Bi<sub>0.1</sub>TiO<sub>3</sub> thin films

Effect of Zn-Doping on the Tunable Behavior of (pb0.6sr0.4)tio3 Thin Films

Enhanced Piezoresponse and Dielectric Properties for Ba1-XSrXTiO3 Composition Ultrathin Films by the High-Throughput Method

Preparation of Dielectric Tunable Zn-Doped PST Thin Films

Strain-assisted control of high stable dielectric tunability in (100) oriented (Pb,Sr)TiO3 thin films

Preparation of (1−%)(NaBi)TiO–%SrTiO thin films by a sol–gel method for dielectric tunable applications

Effect of Lead on Formation and Dielectric Tunability of (pbx,sr1−x )0.85bi0.1tio3 Thin Films

Study of structural and dielectric properties of Ba0.6Sr 0.4(ZrXTi1-X)O3 ceramic

Phase Stability and Ferroelectric Properties of Lead Strontium Zirconate Titanate Ceramics

Giant Dielectric Tunable Behavior of Pr-Doped Srtio3 at Low Temperature

Enhanced Fatigue-Endurance of Ferroelectric Pb1−xSrx(Zr0.52Ti0.48)O3 Thin Films Prepared by Sol-Gel Method