Abstract:Compared with the globe valves and other on-off valves, cavitation and noise are more severe in the throttle control valve of the refrigerating system due to the higher saturated vapor pressure of the refrigerant. A short tube throttle valve (STTV) is an important throttle control component and cavitation noise easily occurs because of the pressure drop caused by flow throttling. To suppress the cavitation noise, this paper proposed a numerical investigation verified by experimental data into cavitation and noise characteristics inside the STTV. Three kinds of typical throttle valve structures are proposed in this study. The flow field and cavitation noise of the STTV under different refrigerant flow rates were analyzed numerically. The noise levels of the prototype and three optimized structures are comparatively assessed and analyzed. The findings indicate that the level of cavitation noise rises with an increase in flow rate through the STTV. Specifically, when the flow rate transitions from 0.014 kg/s to 0.024 kg/s, there is a corresponding increase in noise levels, moving from 102.8 dB to 122.5 dB. There is less cavitation noise upstream and the flow is stable, while the noise is mainly concentrated downstream with symmetrical distribution characteristics. The distribution seems to have small noise near the internal wall, while large noise is in the center of the downstream in the STTV, and the maximum noise is observed at the corner of the valve seat of the valve outlet. The optimized valve featuring a slope structure on the valve seat significantly reduces cavitation noise, with a maximum noise reduction of 24.94 dB compared to the prototype valve.

Noise Reduction Design of Steam Control Valve

Flow-induced vibration and noise in control valve

The Effects of the Orifice Plate Structure on the Aerodynamic Noise in the High Parameter Pressure Reducing Valve

Effects of Throttling Orifice Plate on Flow and Aerodynamic Noise Characteristics Inside Valve Downstream

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Simulation and Design Improvement of a Low Noise Control Valve in Autonomous Underwater Vehicles

Numerical Simulation and Structure Improvement of Double Throttling in A High Parameter Pressure Reducing Valve

Modeling and Characteristics Investigation on a Load Control Valve

Improvement of Noise Reduction Structure of Direct-Acting Pressure Reducing Valve

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Effect of Sleeve Orifices Ratio on Flow Performance and Hydrodynamic Noise in the Two-Stage Sleeve Control Valve

Cavitation and Acoustic Analysis of Sleeve Steam Trap under Multiple Working Conditions

Flow-induced Noise Mechanism and Optimization Design of Electronic Expansion Valve

A New Design Method for the Transition Region of the Valve Plate for an Axial Piston Pump

Design optimization of noise reduction for labyrinth control valve in secondary circuit flow regulation system

Noise Reduction of an Axial Piston Pump by Valve Plate Optimization

Investigation of the Flow-Induced Noise and Optimization Design of a Short Tube Throttle Valve

Design and Simulation of Pneumatic Proportional Extra-High Pressure Valve

Flow Rate Adjustable Ratio Analysis of a Novel Control Valve with Double Sleeve

Throttling Components Effect on Aerodynamic Performance of Superheated Steam Flow in Multi-Stage High Pressure Reducing Valve

Multi-objective Drive Forward Design with Damping Orifice and Groove for Axial Piston Pump