A 4.8db NF, 70-to-86ghz Deep-Noise-Canceling LNA Using Asymmetric Compensation Transformer and 4-to-1 Hybrid-Phase Combiner in 40nm CMOS
Changxuan Han,Jie Zhou,Zhixian Deng,Yiyang Shu,Xun Luo
DOI: https://doi.org/10.1109/isscc42615.2023.10067549
2023-01-01
Abstract:Increasing demands on high data-rates accelerate the development of low-noise receiver systems for modern wireless applications, such as multi-Gb/s data-rate E-band cellular backhaul networks [1]. The noise from a low-noise amplifier (LNA) is the main part of the total noise for a receiver system. Thus, noise figure (NF) is one of the most crucial features for the LNA. To decrease the NF of an LNA, a common approach utilizes a noisecanceling technique [2]. In this way, an additional auxiliary amplifier is introduced to counteract noise generated by the main amplifier. The conventional implementation is a common-gate (CG)-based topology in the first stage of the LNA (Fig. 25.3.1 top). However, due to the influence of parasitics from transistors and routings at a millimeterwave band, there are unavoidable amplitude and phase mismatches for signals and noises between CG and common-source (CS) paths. For analysis, $\mathsf{A}_{\mathsf{G}}$ and $\mathsf{A}_{\mathsf{S}}$ are defined as the gain reduction in CG and CS paths, respectively. Thus, an amplitude mismatch of $\mathsf{A}_{\mathsf{G}}/\mathsf{A}_{\mathsf{S}}$ exists between CG and CS paths. Besides, $\Delta\varphi$ is the phase mismatch between the two paths. From the equation in Fig. 25.3.1, the noise factor of the CG-based stage $(\mathsf{F}_{1})$ is deteriorated with the increase of mismatch. The effect of noise cancellation is weakened due to the mismatches, while the power of the combined signal is reduced. Besides, since the transconductance of transistors becomes low with increasing frequency, the power gain of the LNA first stage is limited, which leads to a dominant noise contribution from the second stage $(\mathsf{F}_{2})$ to the total noise of the LNA. Then, to improve the gain of the first stage, $\mathsf{G}_{\mathsf{m}}$ -boosting techniques are widely used in millimeter-wave bands [2–6]. However, with increased $\mathsf{G}_{\mathsf{m}}$ , the amplitude and phase mismatches between CG and CS paths are enlarged. Thus, noise canceling in the second stage is necessary.