Abstract:We report an experimental investigation on the effect of emulsifiers on the dripping-to-jetting transition and droplet size scaling in a co-flow microcapillary device. The emulsifiers studied include an oil-soluble surfactant Span 80, a water-soluble nanosheet, and their combination. We characterize the dispersed phase behaviors in the state space comprising the Weber number of the inner phase We in and the capillary number of the outer phase Ca out . Results show that the dripping-to-jetting (D-J) transition occurs at We in ≈ O(1) for the no-emulsifier case and We in ≈ 65 for the Span 80 system. In the case of the nanosheet, the D-J transition is dependent on concentration with We in ≈ 0.08–5.6. For the combination system, depending on the nanosheet concentration, the critical We in varies from 0.3 to 21. We explain that these emulsifier-dependent critical We in result in terms of additional interfacial stresses arising due to surfactant transport and adsorbed nanosheets. Combining droplet size data from this study and literature, we find that in the dripping regime, the droplet diameter decreases with increasing Ca out , yielding a scaling exponent of ≈−0.33 and a pre-factor that could be dependent on the type of emulsifier. In the jetting regime, the droplet diameter increases with the flow rate ratio of the two phases, with a scaling exponent of ≈ 0.37 that is independent of the type of emulsifier. The results from this work help to better understand the influence of surfactants and particulate emulsifiers in microfluidic emulsification.

PRODUCTION OF SUB-MICROMETER SIZE O/W EMULSIONS USING A HIGH-PRESSURE WET-TYPE JET MILL

Hydrodynamic Cavitation As an Efficient Method for the Formation of Sub-100 Nm O/W Emulsions with High Stability

High-throughput Emulsification in a Microporous Tube-in-tube Microchannel Device: O/W Emulsion Formation

Improving rheological characteristics of hydrophilic ointment base by treatment with a high-pressure wet-type jet mill

Emulsification in a high-throughput microporous tube-in-tube microchannel system: water in oil emulsion formation

Microfluidic emulsification with a surfactant and a particulate emulsifier: Dripping-to-jetting transitions and drop size scaling

Manipulating The Generation Of Uniform O/W And W/O Emulsions Using Microfluidic T-Junction

Membrane emulsification: Droplet size and uniformity in the absence of surface shear

Millimeter-Size Pickering Emulsions Stabilized with Janus Microparticles.

Study of Surface Tension and Atomization of W/O Emulsions

Emulsification in a Microfluidic Flow-Focusing Device: Effect of the Viscosities of the Liquids

Manipulating T-Junction Chip for the Generation of Uniform O/W and W/O Emulsions

Membrane emulsification using membranes of regular pore spacing: Droplet size and uniformity in the presence of surface shear

Production of Monodisperse Large Drop Emulsions by Means of High Internal Phase Pickering Emulsions-Processing and Formulation

Jetting to dripping transition: Critical aspect ratio in step emulsifiers

Droplet Size Distribution in Emulsions

Experimental and theoretical analysis of emulsification characteristics using a high porosity microscreen under oscillatory shear conditions

Preparation of O/W Emulsion with Microfiltration Membrane

Microfluidic production of aqueous suspensions of gellan-based microcapsules containing hydrophobic compounds

A Basic Study on Micropore Membrane Emulsification

Interface Coupling and Droplet Size under Various Flow-Focusing Geometry Dimensions in Double Emulsion Formation