Emulsification in a high-throughput microporous tube-in-tube microchannel system: water in oil emulsion formation

LI Ting,SHAN CongYun,ZHOU Yue,WANG QiAn,WANG JieXin
DOI: https://doi.org/10.3969/j.issn.1671-4628.2012.01.014
2012-01-01
Abstract:A water in oil(W/O) emulsion has been successfully prepared in a novel high-throughput microporous tube-in-tube microchannel(MTMC) device.The effects of varying the volume ratio of soybean oil to n-hexane in the continuous phase,the surfactant mass fraction,micropore size and annular channel width on the droplet size were investigated in detail.The optimum conditions were obtained as follows: a soybean oil to n-hexane volume ratio of 8∶10,a mass fraction of Span 80 of 1.0%,a micropore size of 5 μm,and an annular channel width of 250 μm.Under these conditions,emulsion droplets with an average size of 13 μm and good monodispersity could be obtained.Emulsification in MTMC offers advantages over typical homogenizers and a Y-junction microchannel,and a high throughput of >1 L/min was obtained.In addition,the effects of structural parameters on the emulsification pressure drop were investigated.The results showed that the emulsification pressure drop increased with decreasing micropore size and annular channel width.
What problem does this paper attempt to address?