Abstract:AbstractThe Laue microdiffraction technique was used to investigate the strain field caused by the shot-peening operation and its redistribution after thermal hold or fatigue in a model nickel-based superalloy with an average grain size of 40μm$$40\,{\upmu }\hbox {m}$$. Micrometer and millimeter size mappings showed that the plastic deformation introduced by shot-peening in the whole sample partially relaxes after a thermal exposure at 450∘C$$450^{\circ }\hbox {C}$$ and was fully redistributed by the fatigue of the material, except in the hardened layer close to the sample edge. Diffraction patterns permitted to measure separately the strains related to the average alloy (γ+γ′$$\gamma +\gamma ^{\prime }$$) and to the γ′$$\gamma ^{\prime }$$ phase. No difference was observed between the two deviatoric strain fields. Even if there were small stresses in the inner part of the samples, the sensitivity of the Laue microdiffraction method was large enough to quantitatively characterize the crystal misorientations and the deviatoric strain redistributions. Useful data were provided not only at the grain scale but also at the mesoscopic scale, thus bridging the gap between the sin2ψ$$\hbox {sin}^{2}\psi $$ and Ortner’s methods used to determine residual stresses, respectively, in fine and single-grain microstructures. The obtained results are also of first interest for a quantitative comparison with HR-EBSD measurements in the scanning electron microscope. Energy coupled measurements with an energy-dispersive point detector were also performed to determine the full elastic strain tensors associated with the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. We demonstrated that, for Ni-based superalloys, the accuracy on strains and stresses was, respectively, of the order of 1×10-3$$1\times 10^{-3}$$ and 250 MPa for the diagonal components of tensors. The measurements suffered from the 150 eV resolution of the detector which made it difficult to the separate the energies of the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. Owing to large crystal misorientations, the microdiffraction technique was not able to determine elastic strains and hardening in the highly deformed layer, where a large amount of plastic strain and a number of defects were accumulated. Some improvements are proposed to overcome these difficulties.

Measurement of service-induced internal elastic strains in a single-crystal nickel-based turbine blade with convergent-beam electron diffraction

Characterisation of the creep cavitation process on grain boundaries in a polycrystalline nickel-base alloy 247

Local strain redistribution in a coarse-grained nickel-based superalloy subjected to shot-peening, fatigue or thermal exposure investigated using synchrotron X-ray Laue microdiffraction

Stress-strain Histories in Coatings on Single Crystal Specimens of a Turbine Blade Alloy

Crystal plasticity analysis of fatigue-creep behavior at cooling holes in single crystal Nickel based gas turbine blade components

The creep deformation of a new nickel-base alloy-by-design studied using synchrotron X-ray diffraction

APPLICATION OF NON-CONTACT STRAIN MEASUREMENT TECHNIQUES TO A SINGLE CRYSTAL ALLOY AT ELEVATED TEMPERATURES

Large Lattice Strain In Individual Grains Of Deformed Nanocrystalline Ni

A Study of the Internal Deformation Fields and the Related Microstructure Evolution during Thermal Fatigue Tests of a Single-Crystal Ni-Base Superalloy

In Situ Scanning–digital Image Correlation for High-Temperature Deformation Measurement of Nickel-Based Single Crystal Superalloy

Interaction and superposition of creep damage and high-cycle fatigue of coarse-grained nickel-base alloy 247

In Situ Scanning Electron Microscopy-Based High-Temperature Deformation Measurement of Nickel-Based Single Crystal Superalloy Up to 800°C

Operando Measurement of Lattice Strain in Internal Combustion Engine Components by Neutron Diffraction

HR-EBSD analysis of in situ stable crack growth at the micron scale

Strain Localizations in Notches for a Coarse-Grained Ni-Based Superalloy: Simulations and Experiments

Coupled Thermomechanical Response Measurement of Deformation of Nickel-Based Superalloys Using Full-Field Digital Image Correlation and Infrared Thermography

Study on Fracture Behavior of Nickel-Based Single Crystal Superalloy Subjected to High Temperature Fatigue Using Digital Image Correlation

Full, 3D-Resolved Lattice Strain Tensor Measurements of Specific Crystallographic Defects Extracted from a Bulk Sample

Experimental and Numerical Investigation of High-Temperature Multi-Axial Fatigue

In situ measurement of three-dimensional intergranular stress localizations and grain yielding under elastoplastic axial-torsional loading

Molecular Dynamics Simulations of the Tensile Mechanical Response of Single Crystal/Polycrystalline Nickel