Abstract:Interfacial bonding strength of an epoxy-based adhesive depends on the interfacial interaction between the adhesive and the substrate. Normally, the curing process at the interface accompanied by the interfacial bonding formation is different from that in the bulk, and it is still a big challenge to probe the interfacial bonding formation at a molecular level. In this study, to trace the interfacial structural evolution of a representative formula of epoxy (digylcidyl ether of biphenyl A, DGEBA) and amine hardener [1,2-bis(2-aminoethoxy)ethane, EDDA] with the sapphire and silica substrates upon curing and post-curing steps, sum frequency generation (SFG) vibrational spectroscopy is employed to detect the molecular-level interfacial structural information. For the sapphire substrate, upon curing, backbone methylene (CH2) stretching signals decrease, indicating the formation of a rigid chain network structure and thus losing the local methylene order, while vibrational signals of the sapphire surface hydroxyl (OH) groups (including hydrogen-bonded and unbonded) increase significantly, indicating the formation of a strong hydrogen-bonding and polar interaction between the epoxy adhesive and the sapphire surface. Upon post-curing, increased backbone CH2 signals and decreased sapphire OH signals suggest interfacial chemical bonding formation due to the reaction between the epoxy rings and the sapphire surface OH groups. Orientation analysis confirms the enhanced ordering of the sapphire surface OH groups upon curing and post-curing, in comparison to the uncured epoxy formula. As for the fused silica, weak vibrational signals of the methylene (CH2) and methyl (CH3) groups are observed before curing, while both of them increase slightly for the cured and post-cured epoxy formulae, suggesting relatively less hydrophilic nature of the silica surface compared to that of the sapphire surface, also evidenced by the very weak OH signals upon curing and post-curing. Further measurement on the adhesion strength matches up with the above spectroscopic experimental results, substantiating the correlation between the macroscopic bonding strength of the epoxy adhesive and the microscopic molecular-level structure.

Evidence from infrared ellipsometry for covalent bonding at a polymer/polymer interface with relevance to "lock-up" in pressure-sensitive adhesive laminates

Macroscopic Evidence of Strong Cation-Pi Interactions in a Synthetic Polymer System.

Surface Enrichment by Conventional and Polymerizable Sulfated Nonylphenol Ethoxylate Emulsifiers in Water-Based Pressure-Sensitive Adhesive

An Analysis of Photopolymerization Kinetics and Stress Development in Multifunctional Acrylate Coatings

Simultaneous Measurement of Polymerization Kinetics and Stress Development in Radiation-Cured Coatings: A New Experimental Approach and Relationship between the Degree of Conversion and Stress

Molecular-Level Correlation between Spectral Evidence and Interfacial Bonding Formation for Epoxy Adhesives on Solid Substrates

Revealing Interfacial Structures Between Silica and Epoxy Adhesive Via Spectroscopy and Morphological and Adhesion Tests

A reliability study of adhesion mechanism between liquid crystal polymer and silicone adhesive

Molecular Behavior of Silicone Adhesive at Buried Polymer Interface Studied by Molecular Dynamics Simulation and Sum Frequency Generation Vibrational Spectroscopy

Correlations between adhesion and molecular interactions at buried interfaces of model polymer systems and in commercial multilayer barrier films

Incorporation of vinyl silane and epoxy silane oligomer into 2-EHA-based polyacrylate latexes via mini-emulsion polymerization and investigation of pressure-sensitive adhesive properties on polar and nonpolar surfaces

Interfacial reactions and self-adhesion of polydimethylsiloxanes

Effect of Silane‐coupling Agents on Interfacial Properties of CF/PI Composites

Synthesis of UV rapid curing silicone coatings via photoinitiated thiol-ene click polymerization for pressure-sensitive adhesive

Viscoelastic Response of Poly(dimethylsiloxane) in the Adhesive Interaction with AFM Tips.

UV‐photopolymerized acrylic pressure‐sensitive adhesives with semi‐interpenetration structure: Effect of plasticizer structures on adhesion properties

Investigation of the Mechanical Properties of a Pressure-sensitive Adhesive Part 4 Crosslink Dependence of Molecular Weight Distribution of Sol Fraction of Lightly-crosslinked Acrylic Copolymers

Direct Evidence of π–π Interactions in Transparent Organic–Inorganic Polymer Hybrids of Polystyrene and Silica Gel

A General Purpose Adhesive for Microelectronic Devices

Study on the Mechanical Behavior of Adhesive Interface by Digital Image Correlation

Effect of Interfacial Local Conformation of Polymer Chains on Adhesion Strength