Reverse osmosis fouling mitigation using variable square waves by controlling reject and feed flows based on a distributed control system

Mostefa Ghassoul

DOI: https://doi.org/10.5004/dwt.2021.27169

IF: 1.1

2021-01-01

Desalination and Water Treatment

Abstract:A pseudo-random binary signal (PRBS) type signal superimposed on the operating reject pressure was previously developed to mitigate fouling. The aim was to create a disturbance that results in cleaning the membrane from reversible foulants and hence restoring the membrane near its normal operation. The technique has produced encouraging results. The current paper was an extension of the previous technique where the PRBS was first applied to the reject to confirm the previous results. Then, it was applied to the feed flow, and finally, it was applied to both reject and feed simultaneously but in anti-phase mode. Results have shown that all three techniques have shown a reduction in conductivity and total dissolved salts (TDS). For the flow, the technique has confirmed the previously obtained results when applied to the reject. when applied to the feed only, it did not improve the results significantly. But when applied to the feed and reject, the improvement was quite significant. In fact, the techniques have driven conductivity below 350 μS/cm and TDS below 250 mg/L despite the high temperature. On the flowrate, the third technique has shown a net increase in the flow rate of about 40%. The work was carried out on a lab-scale RO automatically controlled by YOKOGAWA centum VP distributed control system. The mitigation process is automatically triggered when the permeate conductivity hence TDS passes a permissible threshold and/or permeate flowrate is reduced below a certain threshold.

engineering, chemical,water resources