Polyelectrolyte-based sacrificial protective layer for fouling control in RO desalination

Moon Son,Wulin Yang,Szilard Bucs,Maria Nava-Ocampo,J.S. Vrouwenvelder,Bruce E. Logan
DOI: https://doi.org/10.1021/acs.estlett.8b00400
IF: 11.558
2018-01-01
Environmental Science & Technology Letters
Abstract:Reverse osmosis (RO) membranes inevitably foul because of the accumulation of material on the membrane surface. Instead of trying to reduce membrane fouling by chemically modifying the membrane, we took a different approach based on adding a sacrificial coating of two polyelectrolytes to the membrane. After membrane fouling, this coating was removed by flushing with a highly saline brine solution, and a new coating was regenerated in situ to provide a fresh protective layer (PL) on the membrane surface. The utility of this approach was demonstrated by conducting four consecutive dead-end filtration experiments using a model foulant (alginate, 200 ppm) in a synthetic brackish water (2000 ppm of NaCl). Brine removal and regeneration of the PL coating restored the water compared to only 83 +/- 3% for the pristine membrane. The average water flux 2L 1 m n until the flux was decreased by 10% versus its initial flux, compared to The use of a sacrificial PL coating could therefore provide a more sustainable flux to an average of 97 3% of its initial flux, for the PL-coated membranes was 15.5 +/- 0.6 L m(-2)h(-1) until the flux was decreased by 10% versus its initial flux, compared to 13.4 +/- 0.5 L m(-2) h(-1) for the nontreated control. approach for addressing RO membrane fouling.
What problem does this paper attempt to address?