Abstract:Large quantities of abandoned marine soft soil are generated from coastal engineering which cannot be directly utilized for construction without modification. The utilization of traditional binders to modify abandoned marine soft soil yields materials with favorable mechanical properties and cost efficiency. However, the production of traditional binders like cement leads to environmental pollution. This study uses a CGF all-solid-waste binder (abbreviated as CGF) composed of industrial solid waste materials such as calcium carbide residue (CCR), ground granulated blast furnace slag (GGBS), and fly ash (FA), developed by our research team, for the modification of abandoned marine soft soil (referred to as modified soil). It is noteworthy that the marine soft soil utilized in this study was obtained from the coastal area of Jiaozhou Bay, Qingdao, China. Physical property tests, compaction tests, and unconfined compressive strength (UCS) tests were conducted on the modified soil. The investigation analyzed the effects of binder content, compaction delay time, and curing time on the physical, compaction, and mechanical properties of CGF-modified soil and cement-modified soil. Additionally, microscopic experimental results were integrated to elucidate the mechanical improvement mechanisms of CGF on abandoned marine soft soil. The results show that after modification with binders, the water content of abandoned marine soft soil significantly decreases due to both physical mixing and chemical reactions. With an increase in compaction delay time, the impact of chemical reactions on reducing water content gradually surpasses that of physical mixing, and the plasticity of the modified soil notably modifies. The addition of binders results in an increase in the optimum moisture content and a decrease in the maximum dry density of CGF-modified soil, while the optimum moisture content decreases and the maximum dry density increases for cement-modified soil. Moreover, with an increase in binder content, the compaction curve of CGF-modified soil gradually shifts downward and to the right, while for cement-modified soil, it shifts upward and to the left. Additionally, the maximum dry density of both CGF-modified and cement-modified soils shows a declining trend with the increase in compaction delay time, while the optimum moisture content of CGF-modified soil increases and that of cement-modified soil exhibits a slight decrease. The strength of compacted modified soil is determined by the initial moisture ratio, binder content, compaction delay time, and curing time. The process of CGF modification of marine soft soil in Jiaozhou Bay can be delineated into stages of modified soil formation, formation of compacted modified soil, and curing of compacted modified soil. The modification mechanisms primarily involve the alkali excitation reaction of CGF itself, pozzolanic reaction, ion-exchange reaction, and carbonization reaction. Through quantitative calculations, the carbon footprint and unit strength cost of CGF are both significantly lower than those of cement.

Exploring the mechanical response of low-carbon soil improvement mixtures

Sand and silt treatment with novel binders

Multiscale experimental analysis of marine clay stabilized with coal gangue–calcium carbide residue geopolymer

Geopolymer Materials for Low-Pressure Injections in Coarse Grained Soil: Multiscale Approach to the Study of the Mechanical Behaviour and Environmental Impact

Effect of Porosity/Binder Index on Strength, Stiffness and Microstructure of Cemented Clay: The Impact of Sustainable Development Geomaterials

Design of Alkali-Activated Materials and Geopolymer for Deep Soilmixing: Interactions with Model Soils

Silty Clay Stabilization Using Metakaolin-Based Geopolymer Binder

Life cycle assessment of green binder for organic soil stabilization

Mechanical behaviour and permeability of geopolymer mortars

Analysis of Novel Porosity–Water-to-Binder Index for Prediction of Strength, Stiffness and Durability for Cemented Soils

Improvement of mechanical strength of low-plasticity clay soil using geopolymer-based materials synthesized from glass powder and copper slag

Mechanics, durability, and microstructure analysis of marine soil stabilized by an eco-friendly calcium carbide residue-activated coal gangue geopolymer

Synergistic effects of recycled demolition waste and GGBS-FA based geopolymers on the mechanical properties and stabilization mechanism of high plasticity clay

Influence of steel slag content on the mechanical and hydraulic properties of compacted silt-bentonite mixtures

Permeability characteristics and empirical prediction of fine sandy soils stabilized by cement and metakaolin

Mechanical, microstructural and leachability characteristics of ternary geopolymer mortar: a step towards carbon neutral materials

Comparison of Mechanical Properties of the Geopolymer-Solidified Soils Activated by Two Alkaline Oxides

Experimental Feasibility Study of Geopolymer As the Next-Generation Soil Stabilizer

Mechanical Properties and Leaching Characteristics of Geopolymer-Solidified/Stabilized Lead-Contaminated Soil

Physical and Mechanical Properties of All-Solid-Waste-Based Binder-Modified Abandoned Marine Soft Soil

Experimental Study on Enhancing the Mechanical Properties of Sandy Soil by Combining Microbial Mineralization Technology with Silty Soil