Abstract:A nanometer scale mechanism for micro crack propagation under uniaxial tension in single crystals is investigated using phase field crystal (PFC) simulation. The uniaxial tensile loading is strain controlled. And three initial typical stresses of pre-existing center crack in (111) crystal plane of face centered cubic structure are chosen to study the effects of initial stress state on micro-crack propagation. Moreover, the influences of different crystal orientations, when the crystal suffers from uniaxial tension, are also investigated. Due to the influence of time scale and length scale in the PFC method, the motion of dislocations, vacancies, shear band and twinning structure should be observed and described during the propagation process of micro cracks. In addition, the free energy curves of different processes are drawn and discussed in order to explain the different behaviors of the crystal in the propagation of cracks. Simulation results show that the propagation behavior of micro cracks can be closely associated with the initial stress state. It is found that the propagation behavior mainly occurs in the 11>(111) slip system. Besides, the crystal orientation has a significant effect on the mechanism of activation and evolution. In the pre-stretching system, slip dislocation is induced near the micro-crack tip, and then its slide in [011] direction will cause the cleavage of a certain crystal plane, and promote the micro cracks to extend. However, to a certain level, the propagating direction of the micro-crack tip will turn to another slip direction [101]. As a result, zigzag edge appears. By contrast, in the pre-shear system, the tip of the micro crack propagates in a cleavage mode, and results in the appearance of slip dislocation [101] near the micro-crack tip. Afterwards, the motion of slip dislocation promotes the production of vacancies. And owing to the aggregation and combination of vacancies, secondary cracks form and propagate in the process that follows. At the same time, in a pre-deviatoric system, the micro crack propagates forward with direct cleavage of [101] slip direction near the micro-crack tip until the single crystal sample fractures. Furthermore, no slip dislocation appears during the whole process. The mechanism of micro-crack tip propagating behavior varies with crystal orientation. When the crystal orientation angle is lower, the micro-crack tip prefers to produce slip dislocation around it, and the following dislocation slide will induce vacancies, then a secondary crack also forms because of the aggregation and combination of vacancies. On the other hand, when the aggregation degree is higher, the micro-crack tip is inclined to directly propagate in a cleavage mode, and its propagating direction is nearly perpendicular to the stretching direction.

Crack growth on the basal plane in single crystal zinc: experiments and computations

Effects of Crystalline Orientation, Twin Boundary and Stacking Fault on the Crack-Tip Behavior of a Mode I Crack in Nanocrystalline Titanium

Microcrack Initiation Behavior Around Film Cooling Holes in a Ni-based Single Crystal: in Situ Observation and Crystal Plastic Analysis

Crack Propagation Path Selection and Plastic Deformation at a Crack Tip in Zirconium

Phase-field-crystal Simulation of Nano-Single Crystal Microcrack Propagation under Different Orientation Angles

Study on the Effect of Stress State and Crystal Orientation on Micro-Crack Tip Propagation Behavior in Phase Field Crystal Method

Crack Growth in Zirconium Single Crystal under Cyclic Loading: A Molecular Dynamics Simulation

Atomic Scale Investigation of Nanocrack Evolution in Single-Crystal and Bicrystal Metals under Compression and Shear Deformation

Phase-field-crystal study on the evolution behavior of microcracks initiated on grain boundaries under constant strain

Crack propagation paths and fracture of Ni-based single crystal

Typical Characteristics for Creep Fracture Cleavage Plane of Nickel-Based Single Crystal

Evolution of in-plane strain fields onset of a plastically deforming crack in zirconium

Creep Behaviors of Nickel-Based Single Crystal Superalloys Compact Tension Specimen at High Temperature

On the Study of the Initiation of the Micro Crack on the Smooth Surface of Polycrystalline

Crystallographic Mechanism for Crack Propagation in the T7451 Al–Zn–Mg–Cu Alloy

Dynamic Crack Propagation in Copper Bicrystals Grain Boundary by Atomistic Simulation

Initiation and Propagation of a Single Internal 3D Crack in Brittle Material under Dynamic Loads

Crack Front Segmentation and Facet Coarsening in Mixed-Mode Fracture

A Nanoscale Study of Nucleation and Propagation of Zener Types Cracks at Dislocations: Phase Field Crystal Model

Mechanisms of crack propagation in nanoscale single crystal, bicrystal and tricrystal nickels based on molecular dynamics simulation

A Study of Relationship Between Dislocation Configuration of Nanocrack and Brittle-Ductile Mode of Fracture: Atomistic Modeling