Abstract:The parallel channel is widely used in the two-phase flow boiling heat transfer due to its simple structure, but the existence of multiple flow patterns causes a complex and non-unified explanation of the heat transfer mechanisms. In this study, a saturated flow boiling experiment was designed in a parallel mini channel heat sink with R1233zd(E) as the working fluid. By controlling the vapor quality difference at the inlet and outlet to around 0.1-0.2, each single flow pattern was isolated and presented in the test section, and the corresponding variations of heat transfer coefficient (HTC) were discussed. The results showed that the flow pattern during the saturated flow boiling included bubbly flow, slug flow, wavy-annular flow and local dry-out. The transition boundaries between bubbly flow, slug flow and wavy-annular flow showed good agreement with the present criteria, while a modification was made on the transition from wavy-annular flow to local dry-out. The HTC showed a fast increase under low vapor qualities, then became stable and decreased with the increase of vapor quality. In addition, 6 correlations were selected to compare with the measured HTC classified according to the flow patterns. The comparison showed that the present correlations had different prediction accuracies on the HTC data under each flow pattern. The best prediction on the heat transfer during bubbly and slug flow was achieved by Liu and Winterton's model with the MAE of 16.4% and 12.9%, while Li and Wu's model showed the best agreement with the HTC data during wavy-annular flow with the MAE of 9.1%.

Image Analysis of Flow Maldistribution during Boiling in Parallel Minichannels

Visualization of R1233zd(E) Flow Boiling in Parallel Mini-channels

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Application of RQA and SOM for identification of two-phase flow patterns during boiling in horizontal minichannel

3d Reconstruction Of Slug Flow In Mini-Channels With A Simple And Low-Cost Optical Sensor

Visualization of Flow Patterns and Bubble Behavior During Flow Boiling in Open Microchannels

Visualization of Flow Boiling Experiments on Micro/Nanoscale Structured Surfaces in Microchannel

Oscillations During Flow Boiling in Single Microchannels

Influence of the Surface Enhancement on the Flow Boiling Heat Transfer in a Minichannel

Boiling Flow Pattern Identification Using a Self-Organizing Map

Flow Boiling Heat Transfer in A Minichannel with Enhanced Heating Surface

Heat Transfer Characteristics and Flow Pattern Visualization for Flow Boiling in a Vertical Narrow Microchannel

Investigation of fluid flow during flow boiling inside a horizontal rectangular channel with single-sided heating using particle image velocimetry

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

The use of enhanced surface in flow boiling heat transfer in a rectangular minichannel

Experimental Investigation on Flow Pattern and Bubble Behavior during Subcooled Flow Boiling of R1233zd(E) in Parallel Channels

Flow map and measurement of void fraction and heat transfer coefficient using an image analysis technique for flow boiling of water in a silicon microchannel

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Flow Boiling of Water in a Rectangular Metallic Microchannel

R32 Flow Boiling in Horizontal Mini Channels: Part I. Two-phase Flow Patterns