Abstract:Coal spontaneous combustion often wastes resources and causes environmental pollution. Rapid and accurate identification of high temperature areas in coal is essential to reducing such combustion and environmental pollution. The acoustic thermometry method has the benefits of large temperature measurement space, non-contact, and high interference resistance. Determining the attenuation characteristics of acoustic waves in loose coal is the basis and premise for realizing acoustic temperature measurement. Four types of bituminous coal were scanned by computer tomography equipment. A self-designed acoustic attenuation test device was used to test coal samples under different temperatures and particle sizes. The study result demonstrates that the distribution characteristics of loose coal voids are mainly related to the particle size. The smaller the particle size range, the more uniform the void distribution. As the size of the coal particles increases, the voids become larger. The acoustic attenuation coefficients of four coal samples showed an increasing trend as frequency increased. The influence of coal particle size distribution on the acoustic attenuation coefficient was greater than that of temperature and metamorphic degree. The peak values of coal sound attenuation for different particle sizes were around 400, 700, 1100, and 1600 Hz. This indicated that the distribution of voids was the main factor affecting the propagation of acoustic waves. By analysing the attenuation mechanism of the acoustic wave in loose coal, the attenuation of acoustic temperature measurement signal was caused by the combined effect of loose coal on acoustic wave absorption and scattering. The study results provide theoretical support for the realization of acoustic wave detection of high temperature point in loose coal spontaneous combustion.

Preliminary Study on Application of Infrared Thermal Imaging Technology in Combustion Control of Coal-fired Boilers

Research on combustion visualization of coal-fired boilers based on thermal imaging technology

Research on the Cold Flow Field of Petroleum Coke Powder Oxygen-enriched Burner by Infrared Image Processing

Application Study on Starting Mode Without Injecting Fuel Oil Gun to Face-fired Boilers

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

A Brief Review of the Combustion Diagnosing Techniques for Coal-Fired Boilers of Power Plants in China

APPLICATION OF COMBUSTION DIAGNOSIS AND TEMPERATURE DISTRIBUTION MEASUREMENT SYSTEM BASED ON IMAGE PROCESSING TECHNIQUE ON 300MW UTILITY BOILER

APPLICATION OF TGA-FTIR INTEGRATED TECHNOLOGY IN STUDY ON COAL-BURNING BEHAVIOR

Combustion Optimization Technique of Boiler Based on Information Fusion

Intelligent monitoring and high-performance computing method for over-temperature condition of heating surface of large coal-fired boiler in power station

Initial exploration on potential fire hazards detection from coal spontaneous combustion applied by acoustic wave

A review on fundmental research of oxy-coal combustion technology

Research on High Temperature Air Combustion Technology Via Primary Air Enrichment and Preheating Burner

Investigation of Heating Characteristics of Domestic Gas Cookers Via a Methodology of Infrared Thermography

Application Research of Combustion System for Medium and Small Sized Boilers

Numerical Study on Combustion Characteristics of Biogas Cocombustion in a 300MW Coal-Fired Boiler Furnace

The Principle And Performance Analysis Of Oxygen-Enriched Oil-Saving Combustion Technology For Pulverized Coal Firing

Analysis of Index Gases of Coal Spontaneous Combustion Using Fourier Transform Infrared Spectrometer

Application of optical diagnosis technology in biomass combustion

Study on the Flame Monitoring and Combustion Diagnosis Control Optimizing Inside Pulverized Coal Boiler of Power Plant

Experimental and simulation study on preheating pulverized coal and air flow by a heat exchanger using thermal oil