Abstract:In the context of the Laser Interferometer Space Antenna (LISA), the laser subsystems exhibit frequency fluctuations that introduce significant levels of noise into the measurements, surpassing the gravitational wave signal by several orders of magnitude. Mitigation is achieved via time-shifting individual measurements in a data processing step known as time-delay interferometry (TDI). The suppression performance of TDI relies on accurate knowledge and consideration of the delays experienced by the interfering lasers. While considerable efforts have been dedicated to the accurate determination of inter-spacecraft ranging delays, the sources for onboard delays have been either neglected or assumed to be known. Contrary to these assumptions, analog delays of the phasemeter front end and the laser modulator are not only large but also prone to change with temperature and heterodyne frequency. This motivates our proposal for a novel method enabling a calibration of these delays on-ground and in-space, based on minimal functional additions to the receiver architecture. Specifically, we establish a set of calibration measurements and elucidate how these measurements are utilized in data processing, leading to the mitigation of the delays in the TDI Michelson variables. Following a performance analysis of the calibration measurements, proposed calibration scheme is assessed through numerical simulations. We find that in the absence of the calibration scheme, the assumed drifts of the analog delays increase residual laser noise at high frequencies of the LISA measurement band. A single, on-ground calibration of the analog delays leads to an improvement by roughly one order of magnitude, while re-calibration in space may improve performance by yet another order of magnitude. Towards lower frequencies, ranging error is always found to be the limiting factor for which countermeasures are discussed.

Optical metrology alignment and impact on the measurement performance of the LISA Technology Package

Fundamental Performance Determining Factors of the Ultrahigh-Precision Space-Borne Optical Metrology System for the LISA Pathfinder mission

Design of Dedicated Tilt-to-Length Calibration Maneuvers for LISA

The end-to-end testbed of the Optical Metrology System on-board LISA Pathfinder

Coupling of relative intensity noise and pathlength noise to the length measurement in the optical metrology system of LISA Pathfinder

Compensation of front-end and modulation delays in phase and ranging measurements for time-delay interferometry

Design and construction of an optical test bed for LISA imaging systems and tilt-to-length coupling

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

Subtraction of test mass angular noise in the LISA Technology Package interferometer

Spacetime Metrology with LISA Pathfinder

Picometer-stable hexagonal optical bench to verify LISA phase extraction linearity and precision

Coupling of wavefront errors and pointing jitter in the LISA interferometer: misalignments of the interfering wavefronts

Tilt-to-length coupling in LISA Pathfinder: a data analysis

LISA Dynamics & Control: Closed-loop Simulation and Numerical Demonstration of Time Delay Interferometry

Optical testbed for the LISA phasemeter

Experimental verification of intersatellite clock synchronization at LISA performance levels

Misalignment Correction for Free-Form Surface in Non-Null Interferometric Testing

Calibrating the system dynamics of LISA Pathfinder

Simulation of LiCAS Error Propagation

Tilt-to-length coupling in LISA Pathfinder: Long-term stability