Abstract:Periodic sound reduction at some frequencies and high pressure loss could be considered as the disadvantages of simple expansion silencers. Generally, reactive elements are applied in silencers to optimize their acoustic and aerodynamic performance. In this paper, we were going to investigate the combined and independent effects of reactive elements, baffle and extended tubes at the inlet and outlet of simple expansion silencer, on the acoustic performance and pressure loss of simple expansion silencer. Firstly, simple expansion silencer dimensions were determined based on theoretical calculations to attenuate the noise by 10 dB. Secondly, the simulation was performed using COMSOL acoustical module software based on finite element method to predict silencer sound transmission loss and pressure loss, respectively, before and after adding reactive elements. Then, according to ISO7235, ISO3744 and ISO3746 standards noise insertion loss of various silencers under study was measured in a free field and in the following that silencers pressure loss evaluated. Finally, the predicted results with the software were compared with the experimental ones. The addition of the extended tubes increased the transmission loss and insertion loss at low and medium frequencies and mitigated the pressure loss of the silencer compared to the simple expansion silencer. The baffle increased the transmission loss curve in the medium frequencies compared to the simple expansion silencer. The combination of baffle and extended tube elements caused an extraordinary increase in insertion loss and transmission loss at the medium frequencies and a decrease in pressure loss. It could be concluded from the present study that using extended tube might be probably the best choice to reduce pressure loss and increase the acoustic performance of simple expansion silencer at low and medium frequencies and what's more is that the best acoustic performance in medium frequencies can be achieved by using a combination of baffle and extended tube.

Silencer for high-frequency turbocharger compressor noise via an acoustic straightener

Simulation and Improvement of Silencer at Turbocharger Outlet

Prediction and Evaluation of Acoustic Performance of Silencer for Turbocharger Outlet

A novel design for cruiser type motorcycle silencer based on micro perforated elements

Efficient Modelling of Acoustic Metamaterials for the Performance Enhancement of an Automotive Silencer

Acoustic Simulation for Exhaust Silencer of Vehicle Engine with Combined One/Three-Dimensional Approach

Study of acoustic and aerodynamic performance of reactive silencer with different configurations: Theoretical, modeling and experimental

Tunable silencer for rectangular ventilation duct based on composite Helmholtz resonators

Serrations as a Passive Solution for Turbomachinery Noise Reduction

Analysis of Intake Silencer Insertion Loss in a Marine Diesel Engine Turbocharger Based on Computational Fluid Dynamics and Acoustic Finite Element Method

Advancing flow-duct noise control: Examples of innovative silencers

Silencer nozzle vanes, mounted on the suction side of the compressor of a turbo-compressor driven by the exhaust gas

Smart Acoustic Lining for UHBR Technologies Engine Part 1: design of an electroacoustic liner and experimental characterization under flow in rectangular cross-section ducts

Aeroacoustic design and broadband noise predictions of a fan stage with serrated outlet guide vanes

Thermal and acoustic performance of silencing heat exchanger for engine waste heat recovery

Smart Acoustic Lining for UHBR Technologies Engine Part 2: acoustic treatment at the intake of a scaled turbofan nacelle

Development and progress in aeroacoustic noise reduction on turbofan aeroengines

Tactical aircraft noise reduction using fluidic nozzle inserts

Tonal Fan-Noise Radiation from Aero-Engine Bypass with Serrated End Treatments

An Investigation of the Acoustic Enclosure of an Air Conditioning Compressor Using Response Surface Analysis and Topological Rigidity Optimization

Implementation of Active Noise Control in A Multi-Modal Spray Dryer Exhaust Stack