Abstract:InGaN-based materials and structures have attracted extensive attention in developing green light-emitting diodes (LEDs), but the fabrication of high-performance low-dimensional green LEDs is seriously limited to the sample preparation, device construction, green gap, and efficiency droop. In this work, a kind of green LED composed of p-type InGaN layers and a one-dimensional wired ZnO via Ga incorporation, featuring a green wavelength of 520.0 nm and a linewidth of about 34.0 nm, was designed. The LED characteristics, with respect to the peak wavelengths and linewidths, are almost constant at different input currents, indicating the insensibility to the quantum-confined Stark effect commonly observed in InGaN-based light sources. The color coordinate is really close to pure green (0.170, 0.797) of the Rec. 2020 standard. Significantly, the efficiency droop in the fabricated LED is temperate, suggesting that the recombination of carriers can occur toward the n-ZnO:Ga/p-InGaN interface instead of the p-InGaN region. With an increase in Ga-doping concentration in ZnO:Ga wires, the main EL peaks show a significant red shift from 520 to 584 nm in the green and yellow emission spectrum. This wavelength-tuning is further confirmed by the successfully varied color coordinates. The fabrication of one-dimensional wired green LEDs not only can break through the green gap but also can work as a potential candidate to developing solid-state lighting in the visible band for a wide range of practical applications.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsanm.1c02650.Device preparation process of the n-ZnO:Ga MW/p-InGaN heterojunction green light sources; LED characterization of the as-constructed emission devices, with the wire having different sizes and surface morphologies; EL spectra of the as-constructed LEDs and their corresponding relative EQE in which the wires were selected from different samples (PDF)This article has not yet been cited by other publications.

Structural and optical characteristics of GaN/ZnO coaxial nanotube heterostructure arrays for light-emitting device applications

Position-Controlled Aln/Zno Coaxial Nanotube Heterostructure Arrays for Electron Emitter Applications

Structural and Optical Properties of Position-Controlled N-Zno Nanowire Arrays: Potential Applications in Optoelectronics

Heteroepitaxial growth of GaP/ZnS nanocable with superior optoelectronic response.

From powder to nanowire: A simple and environmentally friendly strategy for optical and electrical GaN nanowire films

Understanding the p-Type GaN Nanocrystals on InGaN Nanowire Heterostructures

InGaN/GaN multi-quantum-well nanowires and light emitting

Optical and Electrical Properties of Ga-Doped ZnO Nanowire Arrays on Conducting Substrates

Wavelength-Tunable Green Light Sources Based on ZnO:Ga Nanowire/p-InGaN Heterojunctions

Light Extraction Enhancement of GaN LEDs by Hybrid ZnO Micro-Cylinders and Nanorods Array

Heteroepitaxial Growth of ZnO Nanorod Arrays on GaAs (111) Substrates by Electrochemical Deposition

InGaN/GaN multiple quantum wells grown on nonpolar facets of vertical GaN nanorod arrays

Slanted n-ZnO/p-GaN nanorod arrays light-emitting diodes grown by oblique-angle deposition

GaN-Based LEDs Grown on Graphene-Covered SiO2/Si (100) Substrate

Axial Growth Characteristics of Optically Active InGaAs Nanowire Heterostructures for Integrated Nanophotonic Devices

Cubic GaN and InGaN/GaN quantum wells

Growth and characterization of green GaInN-based light emitting diodes on free-standing non-polar GaN templates

Semiconductor Nanowire Light Emitting Diodes Grown on Metal: A Direction towards Large Scale Fabrication of Nanowire Devices

Light Extraction Efficiency Enhancement of GaN-based Light Emitting Diodes by a ZnO Current Spreading Layer

Enhancement of Light Output Power from LEDs Based on Monolayer Colloidal Crystal

Ingan/Gan Multilayer Quantum Dots Yellow-Green Light-Emitting Diode with Optimized Gan Barriers