Abstract:Activated carbons were prepared from rice hull by one-step phosphoric acid activation in this work. The evolution of pore structure and surface chemistry in the activation temperature range of 170–450°C was investigated through various characterization techniques. The results showed that the development of porosity (extent of activation) was negligible at activation temperature below 300°C, and rapid evolution occurred in 300–400°C. Porous activated carbon with bimodel pore structure (pore<1nm and pore>1nm) and BET surface area as high as 1295m2/g was obtained at 450°C. The ash contents of samples prepared in this study were in the range of 5–21%. The ash contents of carbons prepared in this study initially decreased from 21.03% to 4.89% with the change of temperature from 170 to 300°C, then increased to 8.72% at 450°C. Boehm titration results suggested that low activation temperature (⩽300°C) benefits the formation of acidic surface groups. With the increase of activation temperature from 300 to 350°C, the concentrations of strong, intermediate and weak acidic surface groups decreased from 2.23, 1.87, and 2.73 to 1.66, 1.32, and 2.16mmolH+/g, respectively. Over 350°C, the change of these groups were insignificant. FTIR results revealed the existence of carbonyl-containing, phosphorus-containing groups, and groups containing Si–O bond. The relative concentration of carbonyl-containing groups decreases with an increase in activation temperature, while that of phosphorus-containing groups follows the reverse trend. The content of Si–O decreased first, then slowly increased with the increase of activation temperature. Boehm titration and FTIR (Fourier transform infrared spectroscopy) results indicated that the surfaces of these carbons contain both temperature-sensitive and temperature-insensitive groups. The temperature-sensitive part consists mainly of carbonyl-containing groups, such as carboxylic groups, while the temperature-insensitive part is primarily phosphorus-containing groups and groups containing Si–O bond. This study demonstrated that carbon products with relative low ash content and high activation degree can be prepared from rice hull by H3PO4 activation at suitable temperature.

Effects of the heating history of impregnated lignocellulosic material on pore development during phosphoric acid activation

Activated Carbons Prepared from Rice Hull by One-Step Phosphoric Acid Activation

Enhanced Abundance of Oxygen-Containing Intermediates from Pre-Oxidation of Poplar Sawdust Facilitates Generation of Porous Structures in Activation with Phosphoric Acid

Physical and chemical properties of carbons synthesized from xylan, cellulose, and Kraft lignin by H3PO4 activation

Effect of Co-solution of Carbon Precursor and Activating Agent on the Textural Properties of Highly Porous Activated Carbon Obtained by Chemical Activation of Lignin With H3PO4

Physicochemical Properties of Carbons Prepared from Pecan Shell by Phosphoric Acid Activation

Effect of Two-Stage Process on the Preparation and Characterization of Porous Carbon Composite from Rice Husk by Phosphoric Acid Activation

The Significance of Lignocellulosic Raw Materials on the Pore Structure of Activated Carbons Prepared by Steam Activation

Thermal pretreatment of willow branches impacts yield and pore development of activated carbon in subsequent activation with ZnCl2 via modifying cellulose structure

A Comparative Study of Phenolic Resin-Based Activated Carbons by Means of Supercritical Water Activation and Steam Activation

Syngenetic Effects in Co-Activation of Willow Wood with Homogenous Biochar Facilitate Pore Generation in Activation

Impacts of partial removal of lignin on development of pore structures in activation of Chinese parasol

Effects Of Carbonization On The Co-Activation Of Sludge And Biomass To Produce Activated Coke

Preparation and pore characterization of activated carbon from Ma bamboo (Dendrocalamus latiflorus) by H3PO4 chemical activation

Computer Analysis of the Effect of Activation Temperature on the Microporous Structure Development of Activated Carbon Derived from Common Polypody

Biomass-Based Activated Carbon and Activators: Preparation of Activated Carbon from Corncob by Chemical Activation with Biomass Pyrolysis Liquids

Effects of Activation Conditions on the Properties of Sludge-Based Activated Coke

Sustainable production of porous carbon from biomass: Influence of pre-carbonization on pore evolution and environment impact

Preparation of Activated Carbon from Co-Pyrolysis Activation of Fly Ash and Biomass

Mathematical analysis of the effect of process conditions on the porous structure development of activated carbons derived from Pine cones

Preparation of activated carbon microspheres from phenolic-resin by supercritical water activation