Abstract:In order to investigate the no-vent filling performance under microgravity, the computational fluid dynamic (CFD) method is introduced to the study, where a model aiming at filling a liquid hydrogen (LH2) receiver tank is especially established. In this model, the solid and fluid regions are considered together to predict the coupled heat transfer process. The phase change effect during the filling process is also taken into account by embedding a pair of mass and heat transfer models into the CFD software FLUENT, one of which involves liquid flash driven by pressure difference between the fluid saturated pressure and the tank pressure, and the other one indicates and calculates the evaporation–condensation process driven by temperature difference between fluid and its saturated state. This CFD model, verified by experimental data, could accurately simulate the no-vent filling process with good flexibility. Moreover, no-vent filling processes under different gravities are comparatively analyzed and the effects of four factors including inlet configuration, inlet liquid temperature, initial wall temperature and inlet flow rate, are discussed, respectively. Main conclusions could be made as follows: 1) Compared to the situations in normal gravity, the no-vent filling in microgravity experiences a more adequate liquid–vapor mix, which results in a more steady pressure response and better filling performance. 2) Inlet configuration seems to have negligible effect on the no-vent filling performance under microgravity since liquid could easily reach the tank wall and then cause a sufficient fluid-wall contact under any inlet condition. 3) Higher initial tank wall temperature may directly cause a higher pressure rise in the beginning, while this effect on the final pressure is not significant. Sufficient precooling and reasonable inlet liquid subcooled degree are suggested to guarantee the reliability and efficiency of the no-vent fill under microgravity.

The effects of vertical and horizontal placement on no-vent fill of cryogenic insulated vessels

Numerical investigation of no-vent fill process of cryogens under microgravity condition

Investigation on no-vent filling process of liquid hydrogen tank under microgravity condition

Influence of filling methods on the cool down performance and induced thermal stress distribution in cryogenic tank

Numerical Study of the Filling Process of a Liquid Hydrogen Storage Tank under Different Sloshing Conditions

Performance analysis of no-vent fill process for liquid hydrogen tank in terrestrial and on-orbit environments

Investigation of the Chill-Down Behavior and Thermal Stress Distribution of a Cryogenic Tank During the Filling Process

Variation of interspace pressure of cryogenic tanks after liquid filling

Experimental investigation into storage of confined cryogenic liquids without evaporation venting

Experimental and numerical analysis of the chill-down process of a large horizontal cryogenic storage tank

Experimental study on cool down characteristics and thermal stress of cryogenic tank during LN2 filling process

Regulation of Gas-Liquid Stratified Flow Boiling Dynamic Instabilities in Horizontal Tube: Effects of Heat Load Distribution and Wall Thermal Capacity

Analysis and Modeling of No-Vent Filling Process for Liquid-Hydrogen Tank in Orbital Conditions

Experimental Study on Refrigeration Performance and Fluid Thermal Stratification of Thermodynamic Vent

Numerical Simulation of Vapor Configuration and Bubbles Coalescence in Cryogenic Propellant Tank under Microgravity

Thermodynamic Analysis of Partially Filled Hydrogen Tanks in a Wide Scale Range

Investigation on Performances of Non-Loss Storage for Cryogenic Liquefied Gas

Numerical Simulation on Interface Evolution and Pressurization Behaviors in Cryogenic Propellant Tank on Orbit

Experimental investigation of the influence of different leaking gases on the heat transfer in a HVMLI cryogenic tank after SCLIV

Numerical Study of Liquid Nitrogen Cavitating Flow Through Nozzles of Various Shapes

Experimental Study on Thermal Stress of Cryogenic Tank During Different Cool Down Process